Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Guide for Measurement of Ionizing Dose-Rate Survivability and Burnout of Semiconductor Devices
Automaticky přeložený název:
Příručka pro měření ionizujícího na dávce Hodnotit schopnost přežití a Burnout polovodičových prvků
NORMA vydána dne 1.1.2011
Označení normy: ASTM F1893-11
Poznámka: NEPLATNÁ
Datum vydání normy: 1.1.2011
Kód zboží: NS-51994
Počet stran: 7
Přibližná hmotnost: 21 g (0.05 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
burnout, failure, high dose-rate, integrated circuits, ionizing radiation, latchup, microcircuits, semiconductor devices, survivability, ICS Number Code 31.080.01 (Semi-conductor devices in general)
Significance and Use | ||||||||||
The use of FXR or LINAC radiation sources for the determination of high dose-rate burnout in semiconductor devices is addressed in this guide. The goal of this guide is to provide a systematic approach to testing semiconductor devices for burnout or survivability. The different types of failure modes that are possible are defined and discussed in this guide. Specifically, failure can be defined by a change in device parameters, or by a catastrophic failure of the device. This guide can be used to determine if a device survives (that is, continues to operate and function within the specified performance parameters) when irradiated to a predetermined dose-rate level; or, the guide can be used to determine the dose-rate burnout failure level (that is, the minimum dose rate at which burnout failure occurs). However, since this latter test is destructive, the minimum dose-rate burnout failure level must be determined statistically. |
||||||||||
1. Scope | ||||||||||
1.1 This guide defines the detailed requirements for testing semiconductor devices for short-pulse high dose-rate ionization-induced survivability and burnout failure. The test facility shall be capable of providing the necessary dose rates to perform the measurements. Typically, large flash X-ray (FXR) machines operated in the photon mode, or FXR e-beam facilities are utilized because of their high dose-rate capabilities. Electron Linear Accelerators (LINACs) may be used if the dose rate is sufficient. Two modes of test are described: (1) A survivability test, and (2) A burnout failure level test. 1.2 The values stated in International System of Units (SI) are to be regarded as standard. No other units of measurement are included in this standard. |
||||||||||
2. Referenced Documents | ||||||||||
|
Historická
1.6.2014
Historická
1.12.2011
Historická
1.6.2009
Historická
1.10.2011
Historická
1.10.2011
Historická
1.7.2012
Poslední aktualizace: 01.09.2024 (Počet položek: 2 345 425)
© Copyright 2024 NORMSERVIS s.r.o.