Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Specification for Taper Pipe Threads 60° for Thermoplastic Pipe and Fittings
Automaticky přeložený název:
Standardní specifikace pro kuželové trubkové závity 60 ° pro termoplastů potrubí a armatur
NORMA vydána dne 10.4.2000
Označení normy: ASTM F1498-00
Poznámka: NEPLATNÁ
Datum vydání normy: 10.4.2000
Kód zboží: NS-50513
Počet stran: 11
Přibližná hmotnost: 33 g (0.07 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
Fitting threads, Plastic pipe/tubing/fittings (thermoplastic), Thermoplastics, Taper pipe threads, Plastic pipe threads, Threaded plastic pipe/fittings, taper pipe threads (60°)-thermoplastic pipe/fittings, spec, ICS Number Code 23.040.20 (Plastic pipes)
1. Scope | ||||||
1.1 This specification covers dimensions and gaging of taper pipe threads used on threaded plastic pipe and fittings. 1.2 Threads meeting this specification shall only be used on those plastic materials deemed suitable by the manufacturer. 1.3 Specialty threads or threads not requiring a leak-tight joint are not covered in this specification. Note 1-The terms "wrench makeup" and "wrench tight" are standard terminology for tightness and do not imply using a pipe wrench or other tools which would damage plastic pipe and fittings.1.4 Thread Designations -The type of pipe threads included in this specification are designated by specifying in sequence the nominal pipe size, number of threads per inch, and the thread series symbols as follows in accordance with ANSI/ASME B1.20.1: 3/8-18 NPT. For left-hand threads add LH to the designation, otherwise right-hand threads will be understood. For example: 3/8-18 NPT-LH. 1.4.1 Each of these letters in the symbol has a definite significance as follows: N = National (American Standard) P = Pipe T = Taper1.5 The values stated in inch-pound units are to be regarded as the standard. 1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific precautionary statements, see 7.2.1 and 8.3. |
||||||
2. Referenced Documents | ||||||
|
Chcete mít jistotu, že používáte pouze platné technické normy?
Nabízíme Vám řešení, které Vám zajistí měsíční přehled o aktuálnosti norem, které používáte.
Chcete vědět více informací? Podívejte se na tuto stránku.
Poslední aktualizace: 31.05.2024 (Počet položek: 2 909 934)
© Copyright 2024 NORMSERVIS s.r.o.