Pozor!

Ve Vašem prohlížeči není aktuálně povoleno spouštění Javascriptu. Je možné, že některé funkce nebudou fungovat správně. Pro plnou funkčnost internetového obchodu doporučujeme povolit Javascript. Zde jsou instrukce jak povolit JavaScript ve Vašem webovém prohlížeči.

Zobrazovaná měna: Kč

Zobrazení ceny: bez DPH

NEPLATNÁ ASTM F1397-93(2012) 1.7.2012 náhled

Doplňující informace

ASTM F1397-93(2012)

Standard Test Method for Determination of Moisture Contribution by Gas Distribution System Components

Automaticky přeložený název:

Standardní zkušební metoda pro stanovení vlhkosti Příspěvek plynovou distribuční soustavy komponenty

NORMA vydána dne 1.7.2012

Jazyk
Provedení	PDF - okamžité stažení - 2 199.30 Kč Tištěné - 2 199.30 Kč
Dostupnost	SKLADEM
Cena	2199.30 Kč bez DPH
2 199.30 Kč

Informace o normě:

Označení normy: ASTM F1397-93(2012)
Poznámka: NEPLATNÁ
Datum vydání normy: 1.7.2012
Kód zboží: NS-50150
Počet stran: 11
Přibližná hmotnost: 33 g (0.07 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM

Tisk

Odeslat známému

Dotaz

Kategorie - podobné normy:

Potrubí a součásti potrubí obecně

Anotace textu normy ASTM F1397-93(2012) :

Keywords:

components, contamination, gas distribution, moisture analyzer, moisture contribution, semiconductor processing, water outgassing, ICS Number Code 23.040.01 (Pipeline components in general. Pipelines)

Doplňující informace

Significance and Use

3.1 The purpose of this test method is to define a procedure for testing components being considered for installation into a high-purity gas distribution system. Application of this test method is expected to yield comparable data among components tested for the purposes of qualification for this installation.

1. Scope

1.1 This test method covers testing components for total moisture contribution to a gas distribution system at ambient temperature. In addition, the test method allows testing at elevated ambient temperatures as high as 70°C and of the component moisture capacity and recovery.

1.2 This test method applies to in-line components containing electronics grade materials such as those used in semiconductor gas distribution systems.

1.3 Limitations:

1.3.1 This test method is limited by the sensitivity of current instrumentation, as well as by the response time of the instrumentation. This test method is not intended to be used for test components larger than 12.7-mm (¹/₂-in.) outside diameter nominal size. This test method could be applied to larger components; however, the stated volumetric flow rate may not provide adequate mixing to ensure a representative sample. Higher flow rates may improve the mixing but excessively dilute the sample.

1.3.2 This test method is written with the assumption that the operator understands the use of the apparatus at a level equivalent to six months of experience.

1.4 The values stated in SI units are to be regarded as the standard. The inch-pound units given in parentheses are for information only.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific hazard statements are given in Section 5.