Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Method for Security Glazing Materials And Systems
Přeložit název
NORMA vydána dne 15.10.2021
Označení normy: ASTM F1233-21
Datum vydání normy: 15.10.2021
Kód zboží: NS-1042220
Počet stran: 13
Přibližná hmotnost: 39 g (0.09 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
asset level, ballistic attack, ballistic impacts, ballistic penetration, blunt tool impacts, body passage, chemical deterioration, forced entry, glazing classification, glazing system tests, passage of contraband, physical attack, relation ballistic threats, security glazing, security glazing materials, security glazing systems, spall, thermal stress, threat level, witness plate ,, ICS Number Code 81.040.20 (Glass in building)
Significance and Use | ||||||||
6.1?This test method is based on field experience rather than laboratory analysis. It provides a basis for the comparative evaluation of ballistic/forced entry/containment resistance of security glazings and systems and should not be used to establish or confirm the absolute prevention of forcible entries or forced exits. This test method defines three factors which determine the success or failure of any attempt to forcefully enter (or exit) the glazing or system. They are: (1.1?This test method sets forth procedures whose purpose is limited to the evaluation of the resistance of security glazing materials and systems against the following threats: 1.1.1?Ballistic Impact, 1.1.2?Blunt Tool Impacts, 1.1.3?Sharp Tool Impacts, 1.1.4?Thermal Stress, and 1.1.5?Chemical Deterioration. Note 1:?Specifically exempted from this test method are the
use of power (motor or engine-driven) tools or devices, explosives,
military ordinance (excepting small arms) and tools, processes or
devices requiring more than two persons to transport and
operate.
1.2?The values stated in inch-pounds are to be regarded as the standard. The values given in parentheses are for information only. 1.3?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||
2. Referenced Documents | ||||||||
|
Poslední aktualizace: 22.12.2024 (Počet položek: 2 217 000)
© Copyright 2024 NORMSERVIS s.r.o.