Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Method for Structural Performance of Architectural Glass Products Under the Influence of Uniform Static Loads
Přeložit název
NORMA vydána dne 1.10.2019
Označení normy: ASTM E998-19
Datum vydání normy: 1.10.2019
Kód zboží: NS-978357
Počet stran: 9
Přibližná hmotnost: 27 g (0.06 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
annealed glass, curtain walls, deflection, float glass, fully tempered glass, heat-strengthened glass, insulating glass, laminated glass, monolithic glass, strain gages, uniform static loads, windows,, ICS Number Code 81.040.20 (Glass in building)
Significance and Use | ||
5.1 This test method is a general procedure for testing architectural glass products under uniform static loads. 5.2 Loads on glass in windows, curtain walls, and doors may vary greatly in magnitude, direction, and duration. An understanding of wind loads on the building is required for selection of test loads and interpretation of results with respect to expected exposure at a particular site. 5.3 A thorough understanding of the variations of the strength of glass and the nature of loading is required to interpret results of this test method. 5.4 The proper use of this test method requires a knowledge of the principles of pressure, deflection, and strain measurement. |
||
1. Scope | ||
1.1 This test method is a general test procedure for load tests of glass subjected to uniform static loads. It is applicable for test protocols involving specified loads, load durations, and loading rates. 1.2 This test method is applicable to architectural flat glass of various types; for example, annealed, heat-strengthened, fully tempered, laminated, insulating, and combinations thereof. 1.3 This test method describes a process of applying specific test loads to glass. The test may be conducted using a standard test frame specified herein or a test frame of the user's design. 1.4 The values stated in SI units are to be regarded as standard. The values given in parentheses after SI units are provided for information only and are not considered standard. 1.5 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||
2. Referenced Documents | ||
|
Poslední aktualizace: 01.11.2024 (Počet položek: 2 208 817)
© Copyright 2024 NORMSERVIS s.r.o.