Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Methods for Tension Testing of Metallic Materials [Metric] (Includes all amendments And changes 8/16/2017).
Automaticky přeložený název:
Standardní zkušební metody pro Tension zkoušení kovových materiálů [ Metric ]
NORMA vydána dne 10.10.2001
Označení normy: ASTM E8M-00a
Poznámka: NEPLATNÁ
Datum vydání normy: 10.10.2001
Kód zboží: NS-48403
Počet stran: 22
Přibližná hmotnost: 66 g (0.15 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
accuracy, bending stress, discontinuous yielding, drop-of-the-beam, eccentric force application, elastic extension, elongation, extension-under-load, extensometer, force, free-running crosshead speed, gage length, halt-of-the force, percent elongation, plastic extension, preload, rate of stressing, rate of straining, reduced section, reduction of area, sensitivity, strain, stress, taring, tensile strength, tension testing, yield point elongation, yield strength
1. Scope |
1.1 These test methods cover the tension testing of metallic materials in any form at room temperature, specifically, the methods of determination of yield strength, yield point elongation, tensile strength, elongation, and reduction of area. Note 1—These test methods are the metric companion of Test Methods E 8. Committee E-28 was granted an exception in 1997 by the Committee on Standards to maintain E8 and E8M as separate companion standards rather than combining standards as recommended by the Form and Style manual. Note 2—These metric test methods are essentially the same as those in Test Methods E 8, and are compatible in technical content except that gage lengths are required to be 5D for most round specimens rather than 4D as specified in Test Methods E 8. Test specimens made from powder metallurgy (P/M) materials are exempt from this requirement by industry-wide agreement to keep the pressing of the material to a specific projected area and density. Note 3—Exceptions to the provisions of these test methods may need to be made in individual specifications or test methods for a particular material. For examples, see Test Methods and Definitions A 370 and Test Methods B 557M. Note 4—Room temperature shall be considered to be 10 to 38°C unless otherwise specified. 1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use./p> |
Chcete mít jistotu, že používáte pouze platné technické normy?
Nabízíme Vám řešení, které Vám zajistí měsíční přehled o aktuálnosti norem, které používáte.
Chcete vědět více informací? Podívejte se na tuto stránku.
Poslední aktualizace: 19.05.2024 (Počet položek: 2 902 277)
© Copyright 2024 NORMSERVIS s.r.o.