Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Methods for Nitrogen in the Analysis Sample of Refuse-Derived Fuel
Automaticky přeložený název:
Standardní zkušební metody pro dusíku v analýzy vzorků z Paliva z odpadů
NORMA vydána dne 1.9.2008
Označení normy: ASTM E778-08
Poznámka: NEPLATNÁ
Datum vydání normy: 1.9.2008
Kód zboží: NS-47959
Počet stran: 5
Přibližná hmotnost: 15 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
Kjeldahl method, Nitrogen content, Refuse-derived fuel (RDF), ICS Number Code 75.160.10 (Solid fuels)
Significance and Use | ||||||||||||||
The standard sample is available to producers and users of RDF as a method for determining the weight percent of nitrogen in the analysis sample. Nitrogen is part of the ultimate analysis and can be used for calculation of combustion parameters.
|
||||||||||||||
1. Scope | ||||||||||||||
1.1 These test methods cover the determination of total Kjeldahl nitrogen in prepared analysis samples of solid forms of refuse-derived fuel (RDF). The procedures measure free ammonia or ammonia formed from the conversion of organic nitrogenous compounds such as amino acids and proteins. However, the procedures may not convert the nitrogenous compounds of some wastes to ammonia. Examples of such compounds that may not be measured are nitro compounds, hydrozones, oxines, nitrates, semicarbazones, pyridines, and some refractory tertiary amines. 1.2 Two alternatives are described for the final determination of the ammonia, the Kjeldahl-Gunning Test Method and the Acid-Titration Test Method. 1.3 The analytical data from these test methods are to be reported as part of the ultimate analysis where ultimate analysis is requested. 1.4 These test methods may be applicable to any waste material from which a laboratory analysis sample can be prepared. 1.5 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific precautionary statements see 8.4.1 and Section 9. |
||||||||||||||
2. Referenced Documents | ||||||||||||||
|
Chcete mít jistotu, že používáte pouze platné technické normy?
Nabízíme Vám řešení, které Vám zajistí měsíční přehled o aktuálnosti norem, které používáte.
Chcete vědět více informací? Podívejte se na tuto stránku.
Poslední aktualizace: 22.12.2024 (Počet položek: 2 217 000)
© Copyright 2024 NORMSERVIS s.r.o.