ČSN EN 1991-1-2..
Cookies
Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
ASTM E564-06(2012)
Standard Practice for Static Load Test for Shear Resistance of Framed Walls for Buildings
Automaticky přeložený název:
Standardní praktiky pro statické zatížení Test smykové pevnosti zarámovaných stěn pro budovy
NORMA vydána dne 1.10.2012
Informace o normě:
Označení normy: ASTM E564-06(2012)
Poznámka: NEPLATNÁ
Datum vydání normy: 1.10.2012
Kód zboží: NS-47226
Počet stran: 5
Přibližná hmotnost: 15 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Kategorie - podobné normy:
Anotace textu normy ASTM E564-06(2012) :
Keywords:
framed walls, racking loads, rigid support, shear displacement, shear stiffness, shear strength, ICS Number Code 91.010.30 (Technical aspects)
Doplňující informace
| 1. Scope | ||||||
|
1.1 This practice describes methods for evaluating the shear capacity of a typical section of a framed wall, supported on a rigid foundation and having load applied in the plane of the wall along the edge opposite the rigid support and in a direction parallel to it. The objective is to provide a determination of the shear stiffness and strength of any structural light-frame wall configuration to be used as a shear-wall on a rigid support. 1.2 Limitations—This practice is not intended to be used as a basis for classifying sheathing shear capacity or as an evaluation of combined flexure and shear resulting from the wall being loaded on a flexible foundation. 1.2.1 The effect of sheathing variations is assessed by holding all other variables constant. Permitted variations in framing configuration and boundary conditions, however, require accurate documentation of the test setup to validate across-study comparisons of sheathing contribution to wall shear capacity. 1.3 The values stated in SI units
are to be regarded as standard. The values given in parentheses are
mathematical conversions to inch-pound units that are provided for
information only and are not considered standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||
| 2. Referenced Documents | ||||||
|
Podobné normy:
1.8.2004
NEPLATNÁ
1.6.2013
1.6.2005
NEPLATNÁ
1.4.2013
1.4.2007
1.5.2005
Doporučujeme:
