Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Methods for Chemical Analysis of High-Temperature, Electrical, Magnetic, and Other Similar Iron, Nickel, and Cobalt Alloys
Automaticky přeložený název:
Standardní zkušební metody pro Chemický rozbor vysoké teploty , elektrické, magnetické , a dalších podobných železa, niklu a kobaltu slitiny
NORMA vydána dne 1.6.2006
Označení normy: ASTM E354-93(2006)
Poznámka: NEPLATNÁ
Datum vydání normy: 1.6.2006
Kód zboží: NS-46533
Počet stran: 28
Přibližná hmotnost: 84 g (0.19 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
ICS Number Code 77.140.40 (Steels with special magnetic properties)
Significance and Use | ||||||||||||||||||||||||||||||
These test methods for the chemical analysis of metals and alloys are primarily intended as referee methods to test such materials for compliance with compositional specifications, particularly those under the jurisdiction of ASTM Committee on Steel, Stainless Steel and Related Alloys. It is assumed that all who use these test methods will be trained analysts capable of performing common laboratory procedures skillfully and safely. It is expected that work will be performed in a properly equipped laboratory under appropriate quality control practices such as those described in Guide E 882. |
||||||||||||||||||||||||||||||
1. Scope | ||||||||||||||||||||||||||||||
1.1 These test methods cover the chemical analysis of high-temperature, electrical, magnetic, and other similar iron, nickel, and cobalt alloys having chemical compositions within the following limits: 1.3 Methods for the determination of several elements not included in this standard can be found in Test Methods E 30 and Test Methods E 1019. 1.4 Some of the concentration ranges given in are too broad to be covered by a single method and therefore this standard contains multiple methods for some elements. The user must select the proper method by matching the information given in the Scope and Interference sections of each method with the composition of the alloy to be analyzed. 1.5 The values stated in SI units are to be regarded as standard. In some cases, exceptions allowed in Practice E 380 are also used. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific hazards statements are given in Section and in special "Warning" paragraphs throughout these test methods. 1.6 This method covers the determination of manganese in concentrations from 0.05 to 2.00 percent. 1.7 This method covers the determination of phosphorus in concentrations from 0.002 to 0.08 %. |
||||||||||||||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||||||||||||||
|
Poskytování aktuálních informací o legislativních předpisech vyhlášených ve Sbírce zákonů od roku 1945.
Aktualizace 2x v měsíci !
Chcete vědět více informací? Podívejte se na tuto stránku.
Poslední aktualizace: 07.05.2024 (Počet položek: 2 897 585)
© Copyright 2024 NORMSERVIS s.r.o.