Cookies
Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
ASTM E323-11(2021)
Standard Specification for Perforated-Plate Sieves for Testing Purposes
Přeložit název
NORMA vydána dne 1.9.2021
Informace o normě:
Označení normy: ASTM E323-11(2021)
Datum vydání normy: 1.9.2021
Kód zboží: NS-1038174
Počet stran: 4
Přibližná hmotnost: 12 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Kategorie - podobné normy:
Anotace textu normy ASTM E323-11(2021) :
This specification covers perforated-plate sieves with either round or square apertures, normally mounted in a frame for use in precision testing in the classification of materials according to designated nominal particle size. The materials used in the manufacture of these sieves shall be steel, stainless steel, brass, bronze, or other rigid material. Each plate of specified sieve designation and aperture size shall conform to individually allocated dimensional requirements.
Keywords:
opening, particle size, perforated plate sieves, precision testing, seive analysis, sieve perforated plate, test sieve ,, ICS Number Code 19.120 (Particle size analysis. Sieving)
Doplňující informace
| 1. Scope | ||||||||||
|
1.1?This specification covers perforated plate with either round or square apertures, normally mounted in a frame for use as sieves in precision testing in the classification of materials according to designated nominal particle size. A method for checking the accuracy of perforated sieve plates is included as information in Appendix X1. Note 1:?The perforated-plate sieves covered by this
specification are intended for general precision testing. Some
industries may require more restricted specifications for sieves
for special testing purposes.
Note 2:?For other types of sieves see Specifications
E11 and E161.
Note 3:?Complete instructions and procedures on the use of
test sieves are contained in ASTM STP 447, Manual on Test Sieving
Methods. This manual also contains a list of all ASTM
published standards on sieve analysis procedures for specific
materials or industries.
1.2?The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.3?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||
| 2. Referenced Documents | ||||||||||
|
Doporučujeme:
Aktualizace technických norem
Chcete mít jistotu, že používáte pouze platné technické normy?
Nabízíme Vám řešení, které Vám zajistí měsíční přehled o aktuálnosti norem, které používáte.
Chcete vědět více informací? Podívejte se na tuto stránku.
