Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Method for Contact Measurement of Backface Deformation in Clay Backing During Body Armor Testing (Includes all amendments And changes 4/7/2020).
Přeložit název
NORMA vydána dne 1.2.2017
Označení normy: ASTM E3068-17e1
Poznámka: NEPLATNÁ
Datum vydání normy: 1.2.2017
Kód zboží: NS-680951
Počet stran: 5
Přibližná hmotnost: 15 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
backface deformation, back face deformation, body armor, backing material, ballistic-resistant,, ICS Number Code 13.310 (Protection against crime), 13.340.01 (Protective equipment in general)
Significance and Use |
5.1 U.S. Department of Defense and U.S. Department of Justice standards for assessing the performance of ballistic-resistant torso body armor require the measurement of BFD on backing assemblies made with ROMA Plastilina No. 1®. 5.2 This test method may be applicable for certification testing or for research and development testing. |
1. Scope |
1.1 This test method describes test methods for the contact measurement of backface deformation (BFD) in clay backing caused by a test threat that produces a partial penetration in a body armor test item. 1.2 This test method is applicable to testing of planar and nonplanar soft armor and hard armor. 1.3 This test method is not applicable to testing of helmets. 1.4 The purpose of this test method is to achieve consistent measurements between laboratories and reduce differences that could result from using different measurement techniques. 1.5 It is anticipated that this test method will be referenced by certifiers, purchasers, and other users in order to meet their specific needs. 1.6 This test method does not specify BFD performance requirements for body armor. The performance requirements are included in other standards or specifications. The decision rules for determining conformance to specifications and the consideration of uncertainty are also included in other standards or specifications. 1.7 Units—The values stated in SI units are to be regarded as standard. Where appropriate, mathematical conversions to non-SI units are provided in parentheses for informational purposes. 1.8 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
Chcete mít jistotu, že používáte pouze platné technické normy?
Nabízíme Vám řešení, které Vám zajistí měsíční přehled o aktuálnosti norem, které používáte.
Chcete vědět více informací? Podívejte se na tuto stránku.
Poslední aktualizace: 03.05.2024 (Počet položek: 2 896 946)
© Copyright 2024 NORMSERVIS s.r.o.