ASTM E3003-15

4.1 Properly sized and fitted body armor enhances the safety and performance of the wearer by providing protection while not restricting movement. Having body armor that fits well begins with appropriate and accurate measurements. The measurement guidance of this practice will facilitate consistency of measurement across the body armor industry and will help wearers understand proper measurements.

4.2 Accurate measurements do not necessarily result in well-fitting armor, so this practice goes a step further by providing (1) a method for assessing how closely an armor matches the corresponding wearer measurements, and (4.3 The measurement and fitting guidance specifically addresses officer-stated requirements for side overlap of front and back body armor panels, minimizing the armhole opening, eliminating any “V” gap (or similar) between the front and back panels, and providing vertical coverage on the front torso from the “2^nd uniform shirt button to 2 to 3 finger widths above duty belt.” Those requirements were considered in the development of this practice and the definition of measurements that can be consistently made for any individual.

4.4 This practice describes measurements for the front, back, and sides of the wearer, in addition to girth measurements, to achieve proper sizing of front and back panels and proper fit of the complete armor.

4.5 This practice can be used to train individuals on proper measurement techniques and to train wearers on proper fitting of body armor.

1.1 This practice provides measurement and fit guidance for soft ballistic-resistant or stab-resistant body armor, or both, covering the torso. Proper measurement of the wearer and fitting of armor to that individual are necessary to obtain sufficient coverage of the torso and vital organs while allowing the full range of motion required for officer operations.

1.2 This practice is primarily directed toward law enforcement and corrections officers and addresses measurements for and fit of concealable (normal duty) body armor worn under or over the uniform for both male and female wearers. This practice addresses only body armor composed of front and back protective panels contained within a carrier that positions and holds the panels on the torso.

1.3 Female wearers require more measurements than male wearers to achieve proper armor fit; therefore, the minimum required measurements are specified individually for males and females.

1.4 In addition to the required measurements, optional measurements are recommended when necessary to accommodate the wearer’s body shape and dimensions.

1.5 Measurement guidance is provided in Section 5 of this practice. Section 5 may also be used to train individuals on proper measurement techniques.

1.6 In addition to measurement guidance, this practice provides two tools for assessing armor relative to the intended wearer:

1.7 Units—English units are specified in this standard to be consistent with measurement units used in the United States body armor community. Approximate values in SI units are given in parentheses.

1.8 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.