Cookies
Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
ASTM E2779-10(2017)
Standard Test Method for Determining Particulate Matter Emissions from Pellet Heaters
Přeložit název
NORMA vydána dne 1.9.2017
Informace o normě:
Označení normy: ASTM E2779-10(2017)
Datum vydání normy: 1.9.2017
Kód zboží: NS-693679
Počet stran: 7
Přibližná hmotnost: 21 g (0.05 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Kategorie - podobné normy:
Anotace textu normy ASTM E2779-10(2017) :
Keywords:
biomass fuel, emissions, granular fuel, particulate, particulate fuel, particulate matter, pellet heater, pellet stove,, ICS Number Code 97.100.30 (Solid fuel heaters)
Doplňující informace
| Significance and Use | ||||||||||||||||||||||
|
5.1 This test method is used for determining average emission rates and average emission factors for pellet heaters. 5.1.1 The emission factor is useful for determining emission performance during product development. 5.1.2 The emission factor is useful for the air quality regulatory community for determining compliance with emission performance limits. 5.1.3 The emission rate may be useful for the air quality regulatory community for determining impacts on air quality from pellet heaters. 5.2 The reporting units are grams of particulate per hour and grams of particulate per kilogram of dry fuel. 5.2.1 Appropriate reporting units for comparing emissions from all types of solid fuel fired appliances: g/kg. 5.2.2 Appropriate reporting units for predicting atmospheric emission impacts: g/h or g/MJ. |
||||||||||||||||||||||
| 1. Scope | ||||||||||||||||||||||
|
1.1 This test method covers the fueling and operating protocol for determining particulate matter emissions from fires in pellet or other granular or particulate biomass burning room heaters and fireplace inserts. 1.2 The values stated in SI units are to be regarded as standard. The values given in parentheses are mathematical conversions to inch-pound units that are provided for information only and are not considered standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||||||||||||
| 2. Referenced Documents | ||||||||||||||||||||||
|
Doporučujeme:
