Cookies
Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
ASTM E2769-13
Standard Test Method for Elastic Modulus by Thermomechanical Analysis Using Three-Point Bending and Controlled Rate of Loading
Automaticky přeložený název:
Standardní zkušební metoda pro modul pružnosti termomechanickým analýzu pomocí tříbodového ohybu a řízenou rychlostí Loading
NORMA vydána dne 15.5.2013
Informace o normě:
Označení normy: ASTM E2769-13
Poznámka: NEPLATNÁ
Datum vydání normy: 15.5.2013
Kód zboží: NS-46008
Počet stran: 5
Přibližná hmotnost: 15 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Anotace textu normy ASTM E2769-13 :
Keywords:
elastic modulus, modulus of elasticity, stress, strain, thermomechanical analysis, ICS Number Code 29.035.20 (Plastic and rubber insulating materials)
Doplňující informace
| Significance and Use | ||||||||||||||||
|
5.1 This test method provides a means of characterizing the mechanical behavior of materials using very small amounts of material. 5.2 The data obtained may be used for quality control, research and development and establishment of optimum processing conditions. The data are not intended for use in design or predicting performance. 1.1 This test method describes the
use of linear controlled-rate-of-loading in three-point bending to
determine the elastic modulus of isotropic specimens in the form of
rectangular bars using a thermomechanical analyzer (TMA).
1.2 This test method provides a
means for determining the elastic modulus within the linear region
of the stress-strain curves (see Fig. 1). This test is conducted under
isothermal temperature conditions from –100 to 300 °C.
1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.4 There is no ISO standard equivalent to this test method. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||||||
| 2. Referenced Documents | ||||||||||||||||
|
Doporučujeme:
