Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Method for Torque Calibration or Conformance of Rheometers
Automaticky přeložený název:
Standardní zkušební metoda pro kalibraci nebo točivého momentu shodě reometrů
NORMA vydána dne 1.2.2007
Označení normy: ASTM E2510-07
Poznámka: NEPLATNÁ
Datum vydání normy: 1.2.2007
Kód zboží: NS-45461
Počet stran: 4
Přibližná hmotnost: 12 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
rheometer, calibration, torque, ICS Number Code 17.060 (Measurement of volume, mass, density, viscosity)
Significance and Use | ||||||||
The test method calibrates or demonstrates conformity of the torque signal of a rheometer at ambient temperature. A calibration factor thus determined may be used to obtain correct torque values. This test method may be used in research, development, specification acceptance, and quality control or assurance. |
||||||||
1. Scope | ||||||||
1.1 This test method describes the calibration or performance conformance for the torque signal generated by commercial or custom-built rheometers. The specific range of the test depends upon the torque range of the rheometer. 1.2 SI units are the standard. 1.3 There is no ISO standard equivalent to this test method. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||
2. Referenced Documents | ||||||||
|
Poslední aktualizace: 17.05.2024 (Počet položek: 2 902 148)
© Copyright 2024 NORMSERVIS s.r.o.