Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Specification for Light Source Products for Inspection of Fluorescent Coatings
Automaticky přeložený název:
Standard Specification zdroje světla produkty po inspekci Fluorescent Coatings
NORMA vydána dne 1.6.2011
Označení normy: ASTM E2501-11
Poznámka: NEPLATNÁ
Datum vydání normy: 1.6.2011
Kód zboží: NS-45444
Počet stran: 3
Přibližná hmotnost: 9 g (0.02 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
coating inspection, fluorescent coatings, fluorescent inspection light, Fluorescent coatings, Light source products, ICS Number Code 25.220.01 (Surface treatment and coating in general), 29.140.40 (Luminaries)
Significance and Use | ||||||||||
Light source products conforming to this specification are intended to be used in conjunction with coatings specially formulated with fluorescent colorants as a system for the visual detection of defects in industrial protective coatings. Visible fluorescence from the coating enhances the contrast of coating irregularities and defects and is produced by excitation of visible-activated fluorescent colorants in the coating. Light source products with defined wavelength and intensity properties are required to produce adequate visible fluorescence for easy visual location of defects. A light source product is considered to consist of a light source component incorporated into an optical, electrical, mechanical, and power supply system that makes it suitable for use in an industrial environment. The entire light source product is subject to this standard. The light source component and any subassemblies of the light source product are not subject to this standard This specification is limited to light source products providing excitation in the range from 400 to 420 nm. |
||||||||||
1. Scope | ||||||||||
1.1 This specification provides the requirements for light source products intended for excitation of fluorescent materials used as a system for detection of defects in industrial coatings. This includes the examination of both longer wavelength fluorescing primer coatings as well as non-fluorescent top coatings. 1.2 This specification establishes the radiometric requirements of the light source product in terms of required wavelength range and minimum irradiance. 1.3 This specification establishes safety requirements for the light source product necessary to ensure the product will not pose a threat to visual health. 1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||
2. Referenced Documents | ||||||||||
|
Historická
1.12.2010
Historická
1.6.2013
Historická
1.6.2011
Historická
1.11.2013
Historická
1.11.2012
Historická
1.2.2013
Poslední aktualizace: 22.11.2024 (Počet položek: 2 206 568)
© Copyright 2024 NORMSERVIS s.r.o.