Standard Test Method for Laboratory Measurement of the Effectiveness of Floor Coverings in Reducing Impact Sound Transmission Through Concrete Floors
Automaticky přeložený název:
Standardní testovací metoda pro laboratorní měření efektivity podlahových krytin ve snižování dopadů přenosu zvuku betonových podlahách
NORMA vydána dne 1.4.2016
Označení normy: ASTM E2179-03(2016)
Datum vydání normy: 1.4.2016
Kód zboží: NS-636738
Počet stran: 5
Přibližná hmotnost: 15 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
impact insulation class, impact sound insulation, impact sound pressure level, tapping machine,, ICS Number Code 91.120.20 (Acoustics in buildings. Sound insulation)
|Significance and Use|
5.1 The impact sound rating for a floor assembly is determined both by the basic floor assembly and the floor covering on the upper surface. The same floor covering in combination with different basic floor assemblies will not always give the same impact insulation class (IIC) ratings. This test method is designed to provide data that characterize the floor covering alone when installed over concrete slab floors.
5.2 The ΔIIC rating calculated in is used to compare the effectiveness of different floor coverings on concrete floors.
5.3 The impact insulation class (IIC) calculated for the reference concrete floor with a covering provides an indication of the impact sound insulation that the covering will provide with typical, monolithic concrete floors.
5.4 When the normalized impact sound pressure levels below a bare concrete slab are known, the difference spectrum calculated in may be used to estimate the impact sound pressure levels and hence the IIC that would result if the covering were installed on the slab.
5.5 Note 1: The difference spectrum calculated in 5.6 This test method closely follows that described in ISO 140-8 except that the single number rating used is the impact insulation class (IIC) described in Classification . The description of the standard concrete floor also differs. gives unreliable estimates of the reduction in impact sound pressure levels due to the floor covering when it is placed on a joist floor incorporating a concrete topping (about 50 mm thick) poured directly on the plywood subfloor or steel deck. The estimated impact sound pressure levels are too low.
Note 2: The requirement in Classification that no deviation above the reference contour may exceed 8 dB means that there is no simple relationship between ISO 140-8 test ratings and those generated by this method.
1.1 This test method describes a method for the laboratory measurement of the effectiveness of floor coverings in reducing impact noise from a standard tapping machine through concrete floors. The test results are not necessarily directly related to the subjective evaluations of the floor coverings.
1.2 This test method applies to all floor coverings, whether single or multi-layered, as installed on a standard concrete floor. Multi-layered coverings may be factory-assembled or assembled at the test laboratory.
1.3 The test method applies only to laboratory measurements. It does not apply to the measurement of the effectiveness of a floor covering in a field situation.
1.4 Laboratory Accreditation—A procedure for accrediting a laboratory for performing this test method is given in Method .
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
|2. Referenced Documents|
Poslední aktualizace: 10.05.2021 (Počet položek: 2 444 732)
© Copyright 2021 NORMSERVIS s.r.o.