Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Practice for Examination of Liquid-Filled Atmospheric and Low-Pressure Metal Storage Tanks Using Acoustic Emission
Automaticky přeložený název:
Standardní praxe pro vyšetření Kapalinové atmosférické a nízkotlaký kovové skladovací nádrže s využitím akustické emise
NORMA vydána dne 1.11.2007
Označení normy: ASTM E1930-07
Poznámka: NEPLATNÁ
Datum vydání normy: 1.11.2007
Kód zboží: NS-43632
Počet stran: 11
Přibližná hmotnost: 33 g (0.07 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
acoustic emission, metal storage tanks, above ground storage tanks, ICS Number Code 23.020.10 (Stationary containers and tanks)
1. Scope | ||||||||||||||||
1.1 This practice covers guidelines for acoustic emission (AE) examinations of new and in-service aboveground storage tanks of the type used for storage of liquids. 1.2 This practice will detect acoustic emission in areas of sensor coverage that are stressed during the course of the examination. For flat-bottom tanks these areas will generally include the sidewalls (and roof if pressure is applied above the liquid level). The examination may not detect flaws on the bottom of flat-bottom tanks unless sensors are located on the bottom. 1.3 This practice may require that the tank experience a load that is greater than that encountered in normal use. The normal contents of the tank can usually be used for applying this load. 1.4 This practice is not valid for tanks that will be operated at a pressure greater than the examination pressure. 1.5 It is not necessary to drain or clean the tank before performing this examination. 1.6 This practice applies to tanks made of carbon steel, stainless steel, aluminum and other metals. 1.7 This practice may also detect defects in tank linings (for example, high-bulk, phenolics and other brittle materials). 1.8 AE measurements are used to detect and localize emission sources. Other NDT methods may be used to confirm the nature and significance of the AE indications (s). Procedures for other NDT techniques are beyond the scope of this practice. 1.9 Examination liquid must be above its freezing temperature and below its boiling temperature. 1.10 Superimposed internal or external pressures must not exceed design pressure. 1.11 Leaks may be found during the course of this examination but their detection is not the intention of this practice. 1.12 The values stated in inch-pound units are to be regarded as the standard. The SI units given in parentheses are for information only. 1.13 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in Section 8 . |
||||||||||||||||
2. Referenced Documents | ||||||||||||||||
|
Chcete mít jistotu o platnosti užívaných předpisů?
Nabízíme Vám řešení, abyste mohli používat stále platné (aktuální) legislativní předpisy.
Chcete vědět více informací? Podívejte se na tuto stránku.
Poslední aktualizace: 24.11.2024 (Počet položek: 2 206 712)
© Copyright 2024 NORMSERVIS s.r.o.