Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Practice for Preparation of Airborne Particulate Lead Samples Collected During Abatement and Construction Activities for Subsequent Analysis by Atomic Spectrometry (Withdrawn 2009)
Automaticky přeložený název:
Standardní praxe pro přípravu Airborne částicím Olověné Vzorků odebraných při snižování emisí a stavební činnosti pro následnou analýzu pomocí atomové spektrometrie (Withdrawn 2009 )
NORMA vydána dne 10.1.2000
Označení normy: ASTM E1741-00
Poznámka: NEPLATNÁ
Datum vydání normy: 10.1.2000
Kód zboží: NS-42848
Počet stran: 5
Přibližná hmotnost: 15 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
airborne particulate, digestion, hot plate, lead, microwave, sample preparation, ICS Number Code 13.040.20 (Ambient atmospheres)
Significance and Use |
This practice is to be used for the digestion of airborne particulate lead that has been collected during various construction and renovation practices associated with lead abatement and removal in and around buildings and related structures. It may also be used to treat samples from other workplace environments where airborne lead is suspected to be present, for example, battery recycling, smelting, firing ranges, etc. This practice may be used to prepare samples that have been obtained in order to ensure compliance with OSHA permissible exposure limits (PELs) for airborne lead concentrations.8 |
1. Scope |
1.1 This practice covers the preparation of airborne particulate samples collected during the abatement of lead hazards in and around buildings and related structures. 1.2 This practice describes the digestion procedures for airborne particulate lead samples that are collected on cellulose ester membrane filters during abatement and construction activities. The practice is intended for use with airborne particulate lead samples that are prepared for subsequent analysis by laboratory-based quantitative analytical methods. 1.3 This practice covers the general considerations for quantitative sample digestion for total recoverable lead in airborne particulate using hot plate or microwave heating techniques. 1.4 The values stated in SI units are to be regarded as the standard. 1.5 The following safety hazards caveat pertains only to the procedure section of this practice. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific hazard statements are given in Section 8 and Notes 2, 3, 8, and 10. |
Poslední aktualizace: 21.11.2024 (Počet položek: 2 206 478)
© Copyright 2024 NORMSERVIS s.r.o.