Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Methods for Coating Mass and Chemical Analysis of Zinc-Nickel Alloy Electrolytically Coated on Steel Sheet (Withdrawn 2021)
Automaticky přeložený název:
Standardní zkušební metody pro nátěrových hmot a chemická analýza zinku a niklu elektrolyticky nanesena na ocelový plech
NORMA vydána dne 1.4.2012
Označení normy: ASTM E1659-12
Poznámka: NEPLATNÁ
Datum vydání normy: 1.4.2012
Kód zboží: NS-42548
Počet stran: 7
Přibližná hmotnost: 21 g (0.05 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
atomic absorption spectrophotometry, coated steel sheet, coating mass, nickel, stripping solution, weigh-strip-weigh, zinc , Atomic absorption spectrometry (AAS), Steel sheet, Atomic absorption spectrophotometry/spectroscopy, Chemical analysis--metals/alloys, Coated sheet products, Coating weight, Electrolytic coatings, Nickel alloys, Stripping solution, Weigh-strip-weigh, Zinc alloys, Zinc-nickel alloy, ICS Number Code 25.220.40 (Metallic coatings)
Significance and Use | ||||||||||||||||||||||||||
These test methods for the chemical analysis of zinc-nickel alloy coating on sheet steel are primarily intended as referee methods to test such materials for compliance with compositional specifications such as found in Specification A918, particularly those under the jurisdiction of ASTM Committee A05 on Metallic-Coated Iron and Steel Products. It is assumed that all who use these test methods will be trained analysts capable of performing common laboratory procedures skillfully and safely. It is expected that work will be performed in a properly equipped laboratory under appropriate quality control practices such as those described in Guide E882. These test methods must be applied twice, once to each side of the specimen if coating mass and composition are required for both sides of a coated sheet. Two separate specimens are required for this purpose. |
||||||||||||||||||||||||||
1. Scope | ||||||||||||||||||||||||||
1.1 These test methods cover independently the chemical analysis of each surface of zinc-nickel alloy electrolytically coated on steel sheet. The coatings have chemical compositions within the following limits:
1.2 These test methods are in the following sections:
1.3 The values stated in SI units are to be regarded as standard. In some cases, exceptions allowed in Practice are also used. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||||||||||
|
Historická
1.9.2009
Historická
1.4.2010
Historická
1.8.2008
Historická
1.5.2014
Historická
1.9.2009
Historická
1.12.2013
Poslední aktualizace: 22.12.2024 (Počet položek: 2 217 000)
© Copyright 2024 NORMSERVIS s.r.o.