Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Method for Determination of Trace Quantities of Iron by Visible Spectrophotometry
Přeložit název
NORMA vydána dne 1.5.2022
Označení normy: ASTM E1615-22
Datum vydání normy: 1.5.2022
Kód zboží: NS-1065063
Počet stran: 7
Přibližná hmotnost: 21 g (0.05 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
iron, PDTS, photometric,, ICS Number Code 77.120.99 (Other non-ferrous metals and their alloys)
Significance and Use | ||||||||||
4.1?This test method is suitable for determining trace concentrations of iron in a wide variety of products, provided that appropriate sample preparation has rendered the iron and sample matrix soluble in water or other suitable solvent. Each sample matrix must be investigated for suitability using this test method. 4.2?This test method assumes that the amount of color developed is proportional to the amount of iron in the test solution. The calibration curve is linear over the specified range. |
||||||||||
1. Scope | ||||||||||
1.1?This test method covers the determination of iron in aromatic hydrocarbons, their derivatives, and related chemicals in the range from 0.01 to 0.2 ?g/g using [3-(2-pyridyl)-5,6-bis(4-phenylsulfonic acid)-1,2,4-triazine, monosodium salt, monohydrate] (PDTS)1.2?The limit of detection (LOD) is 0.01 ?g/kg for iron and the limit of quantitation (LOQ) is 0.04 ?g/kg. Note 1:?The LOD and LOQ were calculated using data from the
ILS.
1.3?This test method is intended to be general for the final steps in the determination of iron and does not include procedures for sample preparation. 1.4?The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.5?Review the current Safety Data Sheets (SDS) for detailed information concerning toxicity, first-aid procedures, and safety precautions. 1.6?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.7?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||
2. Referenced Documents | ||||||||||
|
Chcete mít jistotu o platnosti užívaných předpisů?
Nabízíme Vám řešení, abyste mohli používat stále platné (aktuální) legislativní předpisy.
Chcete vědět více informací? Podívejte se na tuto stránku.
Poslední aktualizace: 21.11.2024 (Počet položek: 2 206 478)
© Copyright 2024 NORMSERVIS s.r.o.