Cookies
Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
ASTM E129-74(1993)E01
Test Method for Spectrographic Analysis of Thermionic Nickel Alloys by the Powder Techniques (Withdrawn 1999)
Automaticky přeložený název:
Zkušební metoda pro spektrografickou analýzu Thermionic slitin niklu od Prašné techniky (Withdrawn 1999 )
NORMA vydána dne 1.1.1993
Informace o normě:
Označení normy: ASTM E129-74(1993)E01
Poznámka: NEPLATNÁ
Datum vydání normy: 1.1.1993
Kód zboží: NS-41145
Počet stran: 4
Přibližná hmotnost: 12 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Anotace textu normy ASTM E129-74(1993)E01 :
Keywords:
Aluminum content-Ni/Ni alloys, Chromium content-Ni/Ni alloys, Cobalt content-Ni/Ni alloys, Copper content-Ni/Ni alloys, Iron content-Ni/Ni alloys, Magnesium content-Ni/Ni alloys, Manganese content-Ni/Ni alloys, Nickel alloys, Silicon content-Ni/Ni alloys, Spectrographic analysis, Thermionic nickel alloys, Titanium content-Ni/Ni alloys, thermionic nickel alloys- spectrographic analysis by powder technique,, test
Doplňující informace
| 1. Scope |
|
1.1 This test method covers the determination of the following elements in thermionic nickel alloys in the concentration ranges shown: 1.2 The test method has been designed for inspection testing of nickel alloy thermionic cathodes. It is equally applicable to the determination of the elements listed in 1.1 in any nickel alloy where the nickel content is greater than 98.0%, provided the total sample available exceeds 50 mg. Note 1-The concentration ranges of the elements listed in 1.1 have been established through cooperative testing of secondary standards and by preparation of synthetic standards provided in the method. The scope is underwritten by three primary spectrochemical standards. Cooperative testing of the first two of these standards has provided supporting data for this method.1.3 The values stated in inch-pound units are to be regarded as the standard. 1.4 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
Doporučujeme:
