Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Methods for Strength of Power-Actuated Fasteners Installed in Structural Members
Přeložit název
NORMA vydána dne 1.9.2018
Označení normy: ASTM E1190-11(2018)
Poznámka: NEPLATNÁ
Datum vydání normy: 1.9.2018
Kód zboží: NS-897597
Počet stran: 6
Přibližná hmotnost: 18 g (0.04 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
concrete, drive pin, edge distance, failure modes, fastener, masonry, powder-actuated, power-actuated, shear test, spacing, structural member, tension test, threaded stud ,, ICS Number Code 91.060.99 (Other elements of buildings)
Significance and Use | ||||||||
4.1 These test methods are intended to measure the anchoring capability and shear resistance of power-actuated fasteners to provide information from which applicable design values are to be derived for use in structural applications, such as in members of concrete, concrete masonry, and steel. |
||||||||
1. Scope | ||||||||
1.1 These test methods describe procedures for determining the static axial tensile and shear strengths of power-actuated fasteners installed in structural members made of concrete, concrete masonry, and steel. 1.2 These test methods are intended for use with fasteners that are installed perpendicular to a plane surface of the structural member. 1.3 Tests for combined tension and shear, fatigue, dynamic, and torsional load resistance are not covered. 1.4 The values stated in SI units are to be regarded as standard. The values given in parentheses are mathematical conversions to inch-pound units that are provided for information only and are not considered standard. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||
2. Referenced Documents | ||||||||
|
Poslední aktualizace: 03.09.2024 (Počet položek: 2 346 077)
© Copyright 2024 NORMSERVIS s.r.o.