Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Specification for Thermocouple Connectors (Includes all amendments And changes 5/27/2015).
Automaticky přeložený název:
Standardní specifikace pro termočlánkových konektorů
NORMA vydána dne 15.11.2008
Označení normy: ASTM E1129/E1129M-08e1
Poznámka: NEPLATNÁ
Datum vydání normy: 15.11.2008
Kód zboží: NS-40557
Počet stran: 6
Přibližná hmotnost: 18 g (0.04 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
connector, contact inserts, jack, plug, quick disconnect, thermocouple, thermocouple connector, thermocouple quick disconnect, Connectors (electrical), Electrical contact materials--specifications, Electrical resistance/resistivity, Insulation resistance, Laboratory apparatus--specifications, Thermal analysis (TA), Thermal gradient, Thermocouple quick disconnect, Thermocouples--specifications, ICS Number Code 17.200.20 (Temperature-measuring instruments)
Significance and Use | ||||||||
The widespread use of thermocouple connectors requires standardization of mating dimensions and performance characteristics. This specification describes standardized thermocouple connector dimensions and capabilities and includes test procedures suitable for evaluating the performance of a particular specimen or design. The tests described are not intended for routine inspection or rapid testing of large groups of connectors or for quality control purposes. |
||||||||
1. Scope | ||||||||
1.1 This specification covers separable single-circuit thermocouple connectors with two round pins. Connectors covered by this specification must be rated for continuous use to at least 300 °F (150 °C), but they may optionally be rated higher. 1.2 This specification does not cover multiple-circuit connectors, multi-pin connectors, miniature connectors, or connectors intended primarily for panel mounting. High temperature connectors (for example, those designed for continuous use at temperatures above approximately 500 °F (260 °C)) are not intended to be covered by this specification. 1.3 The values stated in either inch-pound units or SI units are to be regarded separately as standard. 1.4 The following precautionary statement pertains only to the test method portion, Section 9, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||
2. Referenced Documents | ||||||||
|
Chcete mít jistotu o platnosti užívaných předpisů?
Nabízíme Vám řešení, abyste mohli používat stále platné (aktuální) legislativní předpisy.
Chcete vědět více informací? Podívejte se na tuto stránku.
Poslední aktualizace: 24.11.2024 (Počet položek: 2 206 712)
© Copyright 2024 NORMSERVIS s.r.o.