Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Method for Solar Transmittance (Terrestrial) of Sheet Materials Using Sunlight
Přeložit název
NORMA vydána dne 1.5.2023
Označení normy: ASTM E1084-86(2023)
Datum vydání normy: 1.5.2023
Kód zboží: NS-1142748
Počet stran: 6
Přibližná hmotnost: 18 g (0.04 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
sheet materials, solar transmittance, transmittance,, ICS Number Code 17.180.20 (Colours and measurement of light)
Significance and Use |
4.1?Solar transmittance is an important factor in the admission of energy through fenestration, collector glazing, and protective envelopes. This test method provides a means of measuring this factor under fixed conditions. While the data may be of assistance to designers in the selection and specification of glazing materials, the solar transmittance is not sufficient to define the rate of net heat transfer without information on other important factors. 4.2?This test method has been found practical for both transparent and translucent materials, as well as for those with transmittance reduced by highly reflective coatings. This test method is particularly applicable to the measurement of transmittance of inhomogeneous, fiber reinforced, patterned, or corrugated materials since the transmittance is averaged over a large area. 4.3?This test method may be used to measure transmittance of glazing materials at angles up to 60? off normal incidence. Note 1:?A technique similar to the one described but using a
pyrheliometer has been used for the measurement of specular solar
reflectance; however, there is insufficient experience with this
technique for standardization at present.
|
1. Scope |
1.1?This test method covers the measurement of solar transmittance (terrestrial) of materials in sheet form by using a pyranometer, an enclosure, and the sun as the energy source. 1.2?This test method also allows measurement of solar transmittance at angles other than normal incidence. 1.3?This test method is applicable to sheet materials that are transparent, translucent, textured, or patterned. 1.4?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
Poslední aktualizace: 07.10.2024 (Počet položek: 2 349 940)
© Copyright 2024 NORMSERVIS s.r.o.