Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Practice for Preparation of Disk Specimens of Steel and Iron for Spectrochemical Analysis by Remelting
Automaticky přeložený název:
Standardní praxe pro přípravu disku vzorků oceli a litiny pro spectrochemical analýzu přetavením
NORMA vydána dne 1.10.2009
Označení normy: ASTM E1010-09
Poznámka: NEPLATNÁ
Datum vydání normy: 1.10.2009
Kód zboží: NS-40125
Počet stran: 4
Přibližná hmotnost: 12 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
disk specimen, iron, remelt, spectrochemical analysis, steel, Argon atmospheres, Chips, Crucibles, Disk specimens, Drillings, Electrical arcs, Furnaces, Iron, Melting furnace, Optical emission spectrometry (OES), Powder briquettes, Remelted metals, Solid phase materials, Specimen preparation (for testing)--spectrochemical analysis, Spectral data--metals/alloys, Spectrochemical analysis, Spectrochemical analysis--steel, Turnings, ICS Number Code 77.040.30 (Chemical analysis of metals)
Significance and Use | ||||
Most spectrochemical instruments employed for analyzing steel and iron require a solid specimen with a flat surface large enough for analytical excitation and measurement procedures. This practice describes a procedure for converting unusual types of steel and iron samples to satisfactory spectrochemical specimens. |
||||
1. Scope | ||||
1.1 This practice describes the preparation of disk specimens of steel and iron by melting chunks, chips, drillings, turnings, wire, or powder briquets with an electric arc in an argon atmosphere. Solidification of the specimen takes place in the crucible in an argon atmosphere. The disk obtained is suitable for quantitative spectrochemical analysis. 1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use. Specific warning statements are given in 6.2.1, Section 8, and 10.1.2.1. |
||||
2. Referenced Documents | ||||
|
Historická
1.6.2007
Historická
15.11.2013
Historická
1.6.2012
Historická
15.6.2008
Historická
1.5.2011
Historická
1.5.2011
Poslední aktualizace: 23.12.2024 (Počet položek: 2 217 157)
© Copyright 2024 NORMSERVIS s.r.o.