Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Method for Multi-residue Analysis of Pesticides in Dried Cannabis and Hemp Raw Materials Using Liquid Chromatography-Tandem Mass Spectrometry (LC-MS/MS)Přeložit název
NORMA vydána dne 1.3.2023
Označení normy: ASTM D8399-23
Datum vydání normy: 1.3.2023
Kód zboží: NS-1137201
Počet stran: 16
Přibližná hmotnost: 48 g (0.11 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
analyses, cannabis, laboratory, LC-MS/MS, pesticides,, ICS Number Code 11.120.99 (Other standards related to pharmaceutics),71.040.01 (Analytical chemistry in general)
|Significance and Use|
5.1?The analysis and reporting of pesticide content in all forms of cannabis raw material that is grown or processed or both, with the intent of ingestion or consumption, is required to address health and safety concerns, satisfy testing and labeling requirements, and meet the regulatory guidelines of various jurisdictions where cannabis has been legalized for ingestion or consumption for medicinal or recreational purposes, or both. This test method is useful in providing quantitative results for the analytes listed in , which is a subset of the pesticide testing requirements found in regulatory documents for cannabis, not limited to and including Canada, many U.S. states where legalization has occurred, and the European Pharmacopeia 1.1?This test method allows for the concentration determination of the pesticides listed in and shall apply to any dried raw material from a cannabis plant ( , ) regardless of the type of cannabis plant from which it was derived (. , ) For the sake of brevity, the term cannabis shall be used from now on to refer to any type of cannabis plant including those which can be classified as hemp. The procedure includes sub-sampling a ground, homogenous sample, liquid-solid extraction with acetonitrile:acetic acid (100:1, v:v), solid phase extraction with C18 SPE media, dilution in 3 mM ammonium formate in water with 0.1 % formic acid and 3 mM ammonium formate in methanol with 0.02 % formic acid in a 20:80 ratio (v:v) and analysis by LC-MS/MS. This procedure encompasses the entire process from sample preparation to analyte quantitation encompassing a range of 0.005 ?g/g to 0.500 ?g/g.
Note 1:?For this test method, dried raw material from a cannabis plant includes one or more of inflorescence, leaves, or stems.
Note 2:?Certain jurisdictions or regulations may require specific parts of the plant to be included or excluded for analysis and those regulations will take precedence for the selection of plant parts.
1.2?UnitsThe values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3? lists the analytes measured by this test method.
1.4?No recommendations found within this test method shall preclude observance of federal, state, or local regulations, which may be more restrictive or have different requirements.
1.5?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.6?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Chcete mít jistotu, že používáte pouze platné technické normy?
Nabízíme Vám řešení, které Vám zajistí měsíční přehled o aktuálnosti norem, které používáte.
Chcete vědět více informací? Podívejte se na tuto stránku.
Poslední aktualizace: 11.12.2023 (Počet položek: 2 860 589)
© Copyright 2023 NORMSERVIS s.r.o.