Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Performance Specification for Urinary Intermittent CathetersPřeložit název
NORMA vydána dne 1.5.2021
Označení normy: ASTM D8389-21
Datum vydání normy: 1.5.2021
Kód zboží: NS-1028673
Počet stran: 6
Přibližná hmotnost: 18 g (0.04 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
bladder drainage, catheter, continence, intermittent, urinary, urology,
1.1This performance specification establishes performance requirements for the short-term utilization of a single-use, non-balloon- urinary catheter, French sizes 12 through 30 inclusive, used by the medical professions for providing a method of bladder drainage through the urethra. The product is manufactured in various sizes and materials such as latex, silicone, rubber, and various polymers (as well as combinations of these) and is provided non-sterile and sterile for single use only. The non-sterile catheters should be sterilized.
1.2Catheters whose surface has been chemically treated to effect biocompatibility or microbial properties may be tested to this specification. The safety and effectiveness of antimicrobial coatings or their incorporation into device polymer materials are not within the scope of this specification.
1.3Catheters whose surface has been chemically treated to enhance their lubricity may be tested to this specification.
1.4Regulatory bodies may require additional information, such as clinical data, to support the subject products of this standard.
1.5ExclusionsCatheters for non-urethral catheterization, such as for nephrostomy, suprapubic cystostomy, ureterostomy, gastrostomy, enemas, and so forth, are excluded from the scope of this specification.
1.6The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.7This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.8This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Poslední aktualizace: 26.03.2023 (Počet položek: 2 803 549)
© Copyright 2023 NORMSERVIS s.r.o.