Standard Test Method for Evaluation of Automotive Engine Oils in the Sequence IVB Spark-Ignition EnginePřeložit název
NORMA vydána dne 1.4.2021
Označení normy: ASTM D8350-21
Datum vydání normy: 1.4.2021
Kód zboží: NS-1021938
Počet stran: 92
Přibližná hmotnost: 307 g (0.68 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
cam lobe wear, crankcase oils, lubricants, valve-train wear,
|Significance and Use|
5.1This test method was developed to evaluate automotive lubricants effect on controlling valve-train wear and overall engine wear for overhead camshaft engines with direct acting bucket lifters.
5.2Average intake lifter volume loss is used as a measure of an oils ability to prevent valve-train wear.
5.3End-of-test oil iron concentration is used as a measure of an oils ability to prevent overall engine wear.
Note 2:This test method may be used for engine oil specifications such as API SP, and ILSAC GF- 6A, and GF-6B.
1.1This test method measures the ability of an engine crankcase oil to control valve-train wear in spark-ignition engines at low operating temperature conditions. This test method is designed to simulate extended engine cyclic vehicle operation. The Sequence IVB Test Method uses a Toyota 2NR-FE water cooled, 4 cycle, in-line cylinder, 1.5L engine. The primary result is bucket lifter wear. Secondary results include cam lobe nose wear and measurement of iron (Fe) wear metal concentration in the used engine oil. Other determinations such as fuel dilution of the crankcase oil, non-ferrous wear metal concentrations, total fuel consumption, and total oil consumption, can be useful in the assessment of the validity of the test results.
1.2The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.2.1ExceptionsWhere there is no direct SI equivalent such as pipe fittings, tubing, NPT screw threads/diameters, or single source equipment specified.
1.3This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Specific warning statements are provided throughout this document as necessary in each particular section.
1.4This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Poslední aktualizace: 21.10.2021 (Počet položek: 2 535 243)
© Copyright 2021 NORMSERVIS s.r.o.