Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Method for Measuring Friction and Wear Properties of Extreme Pressure (EP) Lubricating Oils with the Roller-Disk Geometry Using SRV Test Machine (Includes all amendments and changes 6/27/2023).
Přeložit název
NORMA vydána dne 1.12.2020
Označení normy: ASTM D8316-20a
Datum vydání normy: 1.12.2020
Kód zboží: NS-1013199
Počet stran: 7
Přibližná hmotnost: 21 g (0.05 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
coefficient of friction, EP additives, EP lubricants, lubricating oil, oscillation, roller, SRV, wear,, ICS Number Code 75.100 (Lubricants, industrial oils and related products)
Significance and Use |
5.1?This test method can be used to determine antiwear properties and coefficient of friction of EP lubricating oils at selected temperatures and loads specified for use in slip-rolling contacts in which high-speed vibrational or start-stop motions are present for extended periods of time under initial high Hertzian line contact pressures. It has found application as a screening test for lubricants used in gears, rolling bearings or cam/follower systems. Users of this test method should determine whether results correlate with field performance or other applications. In comparison to the ball-on-disk geometry as per Test Method D6425, the initial contact pressure is better retained over test time in this roller-on-disk geometry. |
1. Scope |
1.1?This test method covers an extreme pressure (EP) lubricating oils coefficient of friction and its ability to protect against wear when subjected to high-frequency, linear oscillation motion. The test utilizes a roller-on-disc geometry, where the roller is inclined/deflected by 10? to the oscillating movement. The procedure is identical to that described in DIN 51834, Part 4. 1.2?This test method can also be used to determine the ability of a non-EP lubricating oil to protect against wear and its coefficient of friction under similar test conditions. 1.3?The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.4?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
Poslední aktualizace: 16.02.2025 (Počet položek: 2 225 586)
© Copyright 2025 NORMSERVIS s.r.o.