Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Method for Finite Flash Point Determination of Liquid Wastes by Small-Scale Closed Cup Tester
Přeložit název
NORMA vydána dne 15.3.2018
Označení normy: ASTM D8174-18
Datum vydání normy: 15.3.2018
Kód zboží: NS-810985
Počet stran: 13
Přibližná hmotnost: 39 g (0.09 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
combustible, fire risk, flammable, flash point, ignitability, liquid wastes, volatile,, ICS Number Code 13.030.20 (Liquid wastes. Sludge)
Significance and Use |
5.1 This procedure is intended to be used to evaluate the ignitability of liquid wastes. 5.2 Flash point measures the response of the subsample to heat and an ignition source under controlled laboratory conditions. It is only one of a number of properties that shall be considered in assessing the overall flammability hazard of a liquid waste material. 5.3 Flash point can indicate the possible presence of highly volatile and flammable materials in a relatively nonvolatile or nonflammable material. 5.4 This test method uses a small sample volume (2 mL) and short test time (1 min). |
1. Scope |
1.1 This test method covers the procedure for a flash point test, within the range of –20 to 70 °C, of liquid wastes using a small-scale closed cup tester. Note 1: Some apparatus are not designed for subambient
temperature tests, so the testing range would be between 20 °C and
70 °C.
Note 2: This test method is not applicable for liquid waste
that forms a surface film (see Test Method D8175 for Finite Flash Point
Determination of Wastes by Pensky-Martens Closed Cup
Tester).
1.2 Units—The values stated in SI units are to be regarded as the standard. No other units of measurement are included in this standard. 1.3 This standard measures the ignitability properties of liquid wastes (which may be any discarded material), which may include secondary materials, off-specification products, and materials containing free liquids recovered during emergency response actions. Results from this test method may be used as part of a fire risk assessment of the material, but it is the responsibility of the user to perform any additional characterization needed for determination of storage, transport, treatment, or disposal per current regulations. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
Poslední aktualizace: 02.05.2025 (Počet položek: 2 198 171)
© Copyright 2025 NORMSERVIS s.r.o.