Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Guide for Qualification Testing of Coatings Used in Coating Service Level I in Nuclear Power PlantsPřeložit název
NORMA vydána dne 1.3.2019
Označení normy: ASTM D8157-19
Datum vydání normy: 1.3.2019
Kód zboží: NS-939947
Počet stran: 4
Přibližná hmotnost: 12 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
coating qualification, CSLI, test document,, ICS Number Code 27.120.01 (Nuclear energy in general), 87.040 (Paints and varnishes)
|Significance and Use|
4.1 This guide presents concise guidance and approach to developing a test document for qualifying a coating for CSLI service, whether a new or existing coating. Guidance for evaluating existing qualification test data for applicability is presented in Guide D8104.
4.2 The requirements for qualification testing can be found in Quality Assurance Criteria III (Design Control), IX (Control of Special Processes), and XI (Test Control) of 10 CFR 50, Appendix B, as implemented, respectively, by Requirements III, IX, and XI of NQA-1. A test document developed per this guide is intended to be compliant with these requirements.
4.3 This guide implements the guidance provided in Guide D5144 for qualification of coatings for use in CSLI service. Additional guidance is provided in Regulatory Guide 1.54, Revisions 0 through 3, as may be invoked by the licensee.
4.4 For plants with a license basis that predates the requirements of ANSI N5.12 and N101.2, this guide also is applicable. For these plants, the coatings or coating systems may be designated as acceptable, rather than qualified.
4.5 All qualification testing shall comply with the licensee’s approved quality assurance program.
1.1 This guide provides an approach to identifying the need for and development of a test document to qualify coatings for Coating Service Level I (CSLI) service in nuclear power plants.
1.2 It is the intent of this guide to provide a recommended basis for establishing a coatings qualification test document, not to mandate a singular basis for all test documents. Variations or simplifications of the process described in this guide may be appropriate for any given operating or new construction nuclear power plant depending on its licensing commitments.
1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Poslední aktualizace: 20.03.2023 (Počet položek: 2 799 819)
© Copyright 2023 NORMSERVIS s.r.o.