Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Classification for Reporting Solids and Insoluble Water Contamination of Hydrocarbon-Based Petroleum Products When Analyzed by Imaging InstrumentationPřeložit název
NORMA vydána dne 1.5.2017
Označení normy: ASTM D8072-17
Datum vydání normy: 1.5.2017
Kód zboží: NS-683165
Počet stran: 2
Přibližná hmotnost: 6 g (0.01 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
imaging, particle count, water,, ICS Number Code 23.100.60 (Filters, seals and contamination of fluids), 75.120 (Hydraulic fluids)
|Significance and Use|
4.1 The purpose of this code is to simplify the reporting of solid particle counts and water droplet concentrations present in petroleum products when measured by imaging instruments. Industry is accustomed to using a three number code to report contamination levels and so this reporting method for imaging instruments is presented to organize results in a similar format.
4.2 Particle count results as described by this classification are reported per the preferred number ranges in . Preferred numbers were originally developed by Charles Renard and codified in ISO 3. This format is the preferred reporting format since ISO 4406 has no ability to report water.
4.3 Imaging instruments are capable of identifying insoluble water droplets separate from solids, and therefore a suffix code is added after the three (or four) solid particle codes to report water content in parts per million (ppm (v)). To report water content, detected droplets will be converted to ppm (v). The distribution of water droplet size may be reported if it is useful, but it is not required.
1.1 This classification identifies a concise code which can be used by imaging instruments for reporting of solid particles and insoluble water content in hydrocarbon-based petroleum products. The coding system includes the reporting of water content and particle counts in the ≥1 µm range.
Note 1: Calibration is not in accordance with ISO 11171. Comparability to ISO 4406 and its requirements is not inferred.
1.2 It is valid for imaging instruments measuring particle size by projected equivalent particle diameter (see ), and which are calibrated and verified using particle size and count standards traceable to NIST.1.3 Due to the variation of method and instrument types and resolutions, the reporting of results will include the ASTM standard used to conduct the analysis.
1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Chcete pravidelně odebírat informace o nově vycházejících normách z celého světa a to zcela zdarma?
Přihlašte se k odběru. Vše je velice jednoduché a absolutně ZDARMA.
Na výběr máte vydavatele z celého světa.
Poslední aktualizace: 27.01.2023 (Počet položek: 2 662 456)
© Copyright 2023 NORMSERVIS s.r.o.