ASTM D7964/D7964M-14

5.1 The fluidized bed test provides data to assess the relative performances of FCC catalysts. Because results are affected by catalyst pretreatment, feedstock characteristics, and operating parameters, this test method is written specifically to address the accuracy and precision when a common catalyst and oil are tested under the same conditions but at different sites, using Kayser Technologies Advanced Catalytic Evaluation (ACE) unit.Note 1: ASTM International takes no position respecting the validity of any patent rights asserted in connection with any item mentioned in this standard. Users of this standard are expressly advised that determination of the validity of any such patent rights, and the risk of infringement of such rights, are entirely their own responsibility.

5.2 The standard reaction temperature for purposes of the accuracy and precision statement is 532°C [990°F]. Other reaction temperatures can be used in practice; however, yield data developed at temperatures other than 532°C [990°F] will not be the same. Also, test precision may be different at other reaction temperatures.

1.1 This test method covers determining the activity and coke selectivity of either equilibrium or laboratory deactivated fluid catalytic cracking (FCC) catalysts. The activity is evaluated on the basis of mass percent conversion of gas oil feed in a fluidized bed reactor. The coke yield is defined as the mass of carbon laid down on the catalyst, also expressed as a percent of the gas oil feed. The scope of the round robin will be limited to the determination of activity and coke. All other analyses are thus beyond this scope and should be noted as “optional.”

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.