Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Method for Flammability of Electrical Insulating Materials Intended for Wires or Cables When Burning in Horizontal Configuration
Přeložit název
NORMA vydána dne 1.10.2020
Označení normy: ASTM D7936-20
Datum vydání normy: 1.10.2020
Kód zboží: NS-1009363
Počet stran: 3
Přibližná hmotnost: 9 g (0.02 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
cable, electrical insulating material, flame spread, flaming materials, horizontal flame spread, wire,
Significance and Use |
5.1 This horizontal flame test method measures the ability of the material to cease flaming when the source of ignition used is removed. 5.2 This test method also provides a measure of the capability of the material to spread flame by dripping of flaming particles. 5.3 This test method is used to assess the horizontal flame test performance of electrical insulation materials in Test Methods D470. 5.4 In this test method, the test specimens are subjected to one or more specific sets of laboratory test conditions. If different test conditions are substituted or the end-use conditions are changed, it is not always possible by or from this test to predict changes in the fire-test-response characteristics measured. The results are therefore valid only for the fire-test-exposure conditions described in this test method. |
1. Scope |
1.1 This is a fire-test-response standard. 1.2 This fire test method is applicable to the electrical insulation materials contained in wires or cables. 1.3 The ignition source is a gas burner fueled by methane or natural gas. 1.4 Use the values stated in SI units in referee decisions; see IEEE/ASTM SI-10. The values given in parentheses after SI units are provided for information only and are not considered standard. 1.5 This standard is used to measure and describe the response of materials, products, or assemblies to heat and flame under controlled conditions, but does not by itself incorporate all factors required for fire hazard or fire risk assessment of the materials, products, or assemblies under actual fire conditions. 1.6 Fire testing is inherently hazardous. Adequate safeguards for personnel and property shall be employed in conducting these tests. 1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.8 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
Chcete mít jistotu, že používáte pouze platné technické normy?
Nabízíme Vám řešení, které Vám zajistí měsíční přehled o aktuálnosti norem, které používáte.
Chcete vědět více informací? Podívejte se na tuto stránku.
Poslední aktualizace: 14.02.2025 (Počet položek: 2 225 567)
© Copyright 2025 NORMSERVIS s.r.o.