Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Method for Determination of Glycol for In-Service Engine Oils by Gas Chromatography
Přeložit název
NORMA vydána dne 1.11.2021
Označení normy: ASTM D7922-21
Datum vydání normy: 1.11.2021
Kód zboží: NS-1043815
Počet stran: 8
Přibližná hmotnost: 24 g (0.05 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
antifreeze, ethylene glycol, gas chromatography, glycol, headspace, in-service oil, lubricating oil,, ICS Number Code 75.100 (Lubricants, industrial oils and related products)
Significance and Use | ||||||||
5.1Some glycol/antifreeze dilution of in-service engine oil is normal under typical operating conditions. However, excessive glycol dilution can lead to decreased performance, premature wear, or sudden engine failure. This test method provides a means of quantifying the level of glycol based antifreeze dilution, allowing the user to take necessary action. |
||||||||
1. Scope | ||||||||
1.1This test method covers the determination of glycol based antifreeze for in-service engine oil by derivative headspace/gas chromatography. 1.2Sample is derivatized in-situ directly in a headspace sampling vial prior to vapor phase extraction and injection into a gas chromatograph. 1.3The chemistry of the derivatization is unique to the detection of the molecules of ethylene glycol and 1,2-propylene glycol. 1,3-propylene glycol could also be detected but is not used in any known anti-freeze at this time. Other coolant analyses are beyond the scope of this test method. 1.4The derivatization process does not affect glycol breakdown products such as glycolate and formate and hence the presence of these compounds in the oil will not be quantified. 1.5The test method concentration range is from 50 g/g to 1000g/g. Lower levels are possible by method modifications. Higher levels are possible through sample dilution. 1.6UnitsThe values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.7This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.8This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||
2. Referenced Documents | ||||||||
|
Chcete mít jistotu, že používáte pouze platné technické normy?
Nabízíme Vám řešení, které Vám zajistí měsíční přehled o aktuálnosti norem, které používáte.
Chcete vědět více informací? Podívejte se na tuto stránku.
Poslední aktualizace: 30.03.2023 (Počet položek: 2 804 399)
© Copyright 2023 NORMSERVIS s.r.o.