Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Practice for Determining the Dry Fall (Fog) Properties of Protective CoatingsPřeložit název
NORMA vydána dne 1.11.2021
Označení normy: ASTM D7868-21
Datum vydání normy: 1.11.2021
Kód zboží: NS-1043814
Počet stran: 4
Přibližná hmotnost: 12 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
dry fall, dry fog, overspray,, ICS Number Code 87.040 (Paints and varnishes)
|Significance and Use|
5.1?Attachment of overspray particles to vehicles and other surfaces not intended to be coated can result in property damage and insurance claims. Dry fall coatings are formulated such that overspray particles dry as they move through the air, and before they land on horizontal surfaces. These particles can then be brushed off, vacuumed or washed from the surfaces with no damage. This practice can be used to evaluate the dry fall properties of coatings prior to large scale use. The practice can also be used to evaluate whether the coating(s) possess the same dry fall properties when the fallout collects on surfaces with an elevated temperature.
1.1?This practice covers a procedure for qualitatively evaluating the dry fall properties of coatings. The establishment of the test environment and the evaluation procedures are described.
1.2?This practice uses panels containing an automotive finish since these types of surfaces are often the primary concern relating to overspray damage. Panels coated with other systems may be used as collection surfaces when they are deemed to be more representative.
1.3?The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.4?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
|2. Referenced Documents|
Poslední aktualizace: 08.12.2023 (Počet položek: 2 860 270)
© Copyright 2023 NORMSERVIS s.r.o.