Standard Test Methods for Measurement of Yield Stress of Paints, Inks and Related Liquid MaterialsPřeložit název
NORMA vydána dne 1.12.2020
Označení normy: ASTM D7836-13(2020)
Datum vydání normy: 1.12.2020
Kód zboží: NS-1013185
Počet stran: 3
Přibližná hmotnost: 9 g (0.02 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
coaxial cylinder geometry, cone/plate geometry, controlled stress rheometer, rotational speed, rotational viscometer, shear rate, shear stress, vane spindle geometry, yield stress,, ICS Number Code 87.040 (Paints and varnishes),87.080 (Inks. Printing inks)
|Significance and Use|
5.1The yield stress of a material is a measure of the amount of force required to initiate movement of that material in a pipe, through a pump, or from nozzle. The yield stress also characterizes the ability of the material to maintain particles in suspension. Along with viscosity measurements, yield stress measurements have been useful in establishing root causes of flow problems such as excessive orange peel and sagging and in explaining resistance to such problems. After a coating has been applied, flow and leveling tends to be inversely related to yield stress and sag resistance tends to be directly related to yield stress. The ability of an automotive basecoat to keep aluminum and/or mica flakes oriented has been related to yield stress (direct relationship).
1.1These test methods cover three approaches for determining yield stress values of paints, inks and related liquid materials using rotational viscometers. The first method uses a rotational viscometer with coaxial cylinder, cone/plate, or plate/plate geometry. The second method uses a rheometer operating in controlled stress mode with similar geometries. The third method uses a viscometer with a vane spindle.
1.2A non-rotational technique, the falling needle viscometer (FNV), also can be used to measure yield stress values in paints, inks and related materials. See Test Methods , Test Method D, Yield Stress Determination for details.
1.3This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
|2. Referenced Documents|
Poslední aktualizace: 16.10.2021 (Počet položek: 2 534 860)
© Copyright 2021 NORMSERVIS s.r.o.