Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Method for Determination of the Fatty Acid Methyl Esters Content of Aviation Turbine Fuel Using Flow Analysis by Fourier Transform Infrared Spectroscopy—Rapid Screening Method
Přeložit název
NORMA vydána dne 1.3.2023
Označení normy: ASTM D7797-23
Datum vydání normy: 1.3.2023
Kód zboží: NS-1137936
Počet stran: 6
Přibližná hmotnost: 18 g (0.04 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
AVTUR, biodiesel in jet fuel, contamination, FAME, FTIR: FA-FTIR, methyl esters,, ICS Number Code 75.160.20 (Liquid fuels)
Significance and Use | ||||||||||||||||||||||||
5.1?The present and growing international governmental requirements to add fatty acid methyl esters (FAME) to diesel fuel has had the unintended side-effect of leading to potential FAME contamination of jet turbine fuel in multifuel transport facilities such as cargo tankers and pipelines, and industry wide concerns. 5.2?Analytical methods have been developed with the capability of measuring down to <5 mg/kg levels of FAME, however these are complex, and require specialized personnel and laboratory facilities. This Rapid Screening method has been developed for use in the supply chain by non specialized personnel to cover the range of 10 mg/kg to 150 mg/kg. |
||||||||||||||||||||||||
1. Scope | ||||||||||||||||||||||||
1.1?This test method specifies a rapid screening method using flow analysis by Fourier transform infrared (FA-FTIR) spectroscopy with partial least squares (PLS-1) processing for the determination of the fatty acid methyl ester (FAME) content of aviation turbine fuel (AVTUR), in the range of 10 mg/kg to 150 mg/kg. Note 1:?Specifications falling within the scope of this test
method are: Specification D1655 and Defence Standard
91-91.
Note 2:?This test method detects all FAME components, with
peak IR absorbance at approximately 1749 cm-1 and
CNote 3:?Additives such as antistatic agents, antioxidants and
corrosion inhibitors are measured with the FAME by the FTIR
spectrometer. However the effects of these additives are removed by
the flow analysis processing.
Note 4:?FAME concentrations from 150 mg/kg to 500 mg/kg, and
below 10 mg/kg can be measured but the precision could be
affected.
1.2?The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.3?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||||||||
|
Poskytování aktuálních informací o legislativních předpisech vyhlášených ve Sbírce zákonů od roku 1945.
Aktualizace 2x v měsíci !
Chcete vědět více informací? Podívejte se na tuto stránku.
Poslední aktualizace: 03.10.2024 (Počet položek: 2 351 551)
© Copyright 2024 NORMSERVIS s.r.o.