Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Practice for Coding Plastic Manufactured Articles for Resin IdentificationPřeložit název
NORMA vydána dne 1.12.2021
Označení normy: ASTM D7611/D7611M-21
Datum vydání normy: 1.12.2021
Kód zboží: NS-1046317
Počet stran: 4
Přibližná hmotnost: 12 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
plastics, Resin Identification Code,, ICS Number Code 83.140.01 (Rubber and plastic products in general)
Adjunct to D7611/D7611M Standard Practice for Coding Plastic Manufactured Articles for Resin IdentificationVybrané provedení:
|Significance and Use|
4.1Resin Identification Codes are used solely to identify the plastic resin used in a manufactured article. The intended manufactured articles include, but are not limited to, packaging.
4.1.1Fig. 1 and Table 1 present the appropriate information on the way the RIC is to be incorporated onto the product and the available resin identification designations.
FIG. 1Example of a Resin Identification Marker
4.2Resin Identification Codes are not recycle codes. The Resin Identification Code is, though, an aid to recycling. The use of a Resin Identification Code on a manufactured plastic article does not imply that the article is recycled or that there are systems in place to effectively process the article for reclamation or re-use. The term recyclable or other environmental claims shall not be placed in proximity to the Code.
4.3This practice is based upon the system developed in 1988 by the Society of the Plastics Industry, Inc (SPI). It is possible that some states or countries will have incorporated the original SPI practice into statute or regulation. In those situations, that statute or regulation takes precedence over this standard.
4.4This practice shall only apply to new tooling. Existing molds that already incorporate older versions of the SPI RIC may be modified, but modification is not required.
4.5Assign number for manufactured items, not for adhesives or coatings. Do not code labels for resin of the label.
4.6Section 6 addresses the process to add new numbers to the Resin Identification Code.
1.1This practice stipulates the types, names, and sizes of Codes for those material types specified in Table 1.
1.2The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are likely not to be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems is likely to result in non-conformance with the standard.
1.3This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
Note 1:There is no known ISO equivalent to this standard.
1.4This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Poslední aktualizace: 24.03.2023 (Počet položek: 2 803 203)
© Copyright 2023 NORMSERVIS s.r.o.