Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Specification for EFEP-Fluoropolymer Molding and Extrusion Materials
Přeložit název
NORMA vydána dne 1.4.2024
Označení normy: ASTM D7472-19(2024)
Datum vydání normy: 1.4.2024
Kód zboží: NS-1180531
Počet stran: 4
Přibližná hmotnost: 12 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
This specification addresses the physical properties of melt processible molding and extrusion materials of EFEP-fluoropolymer, wherein the EFEP resin is a copolymer of ethylene, tetrafluoroethylene, and hexafluoropropylene. It does not cover blended and recycled materials. Covered here are two types of fluoropolymer that is supplied in pellet form and classified according to their melting points, while the resins of each type are divided into one to two grades in accordance with their melt flow rates. The materials shall be sampled in accordance with an adequate statistical sampling procedure and shall conform to specific gravity, melting point, melt flow rate, elongation, tensile strength, and dielectric constant and dissipation factor requirements when tested by the procedures itemized herein.
Keywords:
copolymer of ethylene, tetrafluoroethylene, and hexafluoropropylene, EFEP copolymer, ETFE copolymer, ethylene copolymer, ethylene-tetrafluoroethylene copolymer, fluoropolymer, tetrafluoroethylene copolymer, TFE copolymer,, ICS Number Code 83.080.20 (Thermoplastic materials)
Poslední aktualizace: 06.02.2025 (Počet položek: 2 224 278)
© Copyright 2025 NORMSERVIS s.r.o.