Cookies
Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
ASTM D746-98e1
Standard Test Method for Brittleness Temperature of Plastics and Elastomers by Impact (Includes all amendments And changes 8/16/2017).
Automaticky přeložený název:
Standardní zkušební metoda pro křehkosti Teplota plastů a elastomerů při nárazu
NORMA vydána dne 10.7.1998
Informace o normě:
Označení normy: ASTM D746-98e1
Poznámka: NEPLATNÁ
Datum vydání normy: 10.7.1998
Kód zboží: NS-38510
Počet stran: 8
Přibližná hmotnost: 24 g (0.05 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Anotace textu normy ASTM D746-98e1 :
Keywords:
temperature, plast, inspection, ICS Number Code 83.060 (Rubber), 83.080.01 (Plast in general)
Doplňující informace
| 1. Scope | ||||||||||||||||||||||
|
1.1 This test method covers the determination of the temperature at which plastics and elastomers exhibit brittle failure under specified impact conditions. Two routine inspection and acceptance procedures are also provided. Note 1—When testing rubbers for impact brittleness use Test Methods D2137. 1.2 The values stated in SI units are to be regarded as the standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Note 2—This test method and ISO 974-1980 (E) are technically equivalent when using the Type B fixture and the Type III specimen, however, the minimum number of specimens that are required to be tested may be significantly different when using this test method. The ISO method requires that a minimum of 100 specimens be tested. |
||||||||||||||||||||||
| 2. Referenced Documents | ||||||||||||||||||||||
|
Doporučujeme:
