Cookies
Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
ASTM D7422-14
Standard Test Method for Evaluation of Diesel Engine Oils in T-12 Exhaust Gas Recirculation Diesel Engine
Automaticky přeložený název:
Standardní zkušební metoda pro hodnocení Oleje dieselového motoru v T - 12 recirkulace výfukových plynů s dieselovým motorem
NORMA vydána dne 1.5.2014
Informace o normě:
Označení normy: ASTM D7422-14
Poznámka: NEPLATNÁ
Datum vydání normy: 1.5.2014
Kód zboží: NS-38415
Počet stran: 38
Přibližná hmotnost: 114 g (0.25 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Anotace textu normy ASTM D7422-14 :
Keywords:
cylinder liner wear, diesel engine oil, exhaust gas recirculation, lead, lubricants, oil consumption, oxidation, soot, T-12 Diesel Engine, top ring mass loss, ultra-low sulfur diesel fuel, ICS Number Code 75.160.20 (Liquid fuels)
Doplňující informace
| Significance and Use | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
5.1 This test method was developed to evaluate the wear performance of engine oils in turbocharged and intercooled four-cycle diesel engines equipped with EGR and running on ultra-low sulfur diesel fuel. Obtain results from used oil analysis and component measurements before and after test. 5.2 The test method may be used for engine oil specification acceptance when all details of the procedure are followed. |
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
| 1. Scope | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
1.1 This test method covers an engine test procedure for evaluating diesel engine oils for performance characteristics, including lead corrosion and wear of piston rings and cylinder liners in an engine equipped with exhaust gas recirculation and running on ultra-low sulfur diesel fuel.1.1.1 This test method also provides the procedure for running an abbreviated length test, which is commonly referred to as the T-12A. The procedures for the T-12 and T-12A are identical with the exception of the items specifically listed in 1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.2.1 Exception—Where there is no direct SI equivalent, such as the units for screw threads, National Pipe Threads/diameters, tubing size, and single source supply equipment specifications. 1.3 This standard does not
purport to address all of the safety concerns, if any, associated
with its use. It is the responsibility of the user of this standard
to establish appropriate safety and health practices and determine
the applicability of regulatory limitations prior to use.
Code of Federal Regulations Title 40 Part 86.310-79 Standard Test Method for Acid Number of
Petroleum Products by Potentiometric Titration (Includes all
amendments and changes 1/4/2019). Standard Test Method for Cetane Number of
Diesel Fuel Oil Standard Test Method for Sulfur in
Petroleum Products by Wavelength Dispersive X-ray Fluorescence
Spectrometry Standard Test Method for Cloud Point of
Petroleum Products and Liquid Fuels Standard Test Method for API Gravity of
Crude Petroleum and Petroleum Products (Hydrometer/Method) Standard Specification for Mineral
Spirits (Petroleum Spirits) (Hydrocarbon Dry Cleaning Solvent) Standard Test Method for Corrosiveness to
Copper from Petroleum Products by Copper Strip Test Standard Specification for Performance of
Active API Service Category Engine Oils (Includes all amendments
and changes 12/8/2022). Standard Test Method for Base Number
Determination by Potentiometric Hydrochloric Acid Titration Standard Test Method for Multielement
Determination of Used and Unused Lubricating Oils and Base Oils by
Inductively Coupled Plasma Atomic Emission Spectrometry
(ICP-AES) Standard Test Method for Determination of
the Aromatic Content and Polynuclear Aromatic Content of Diesel
Fuels By Supercritical Fluid Chromatography Standard Test Method for Determination of
Total Sulfur in Light Hydrocarbons, Spark Ignition Engine Fuel,
Diesel Engine Fuel, and Engine Oil by Ultraviolet Fluorescence
(Includes all amendments and changes 8/13/2019). Standard Test Method for Evaluation of
Diesel Engine Oils in T-8 Diesel Engine Standard Test Method for Evaluating
Lubricity of Diesel Fuels by the Scuffing Load Ball-on-Cylinder
Lubricity Evaluator (SLBOCLE) Standard Test Method for Determination of
Yield Stress and Apparent Viscosity of Used Engine Oils at Low
Temperature (Includes all amendments and changes 11/23/2020). Standard Practice for Using Significant
Digits in Test Data to Determine Conformance with
Specifications Standard Practice for Dealing With
Outlying Observations Standard Test Method for Calculated
Cetane Index of Distillate Fuels (Includes all amendments and
changes 2/23/2023). Standard Test Method for Water and
Sediment in Middle Distillate Fuels by Centrifuge Standard Test Method for Estimation of
Net Heat of Combustion of Aviation Fuels Standard Test Method for Density,
Relative Density, and API Gravity of Liquids by Digital Density
Meter Standard Test Method for Hydrocarbon
Types in Liquid Petroleum Products by Fluorescent Indicator
Adsorption (Includes all amendments and changes 9/14/2020). Standard Test Method for Oxidation
Stability of Distillate Fuel Oil (Accelerated Method) Standard Terminology Relating to
Petroleum Products, Liquid Fuels, and Lubricants (Includes all
amendments and changes 12/21/2023). Standard Test Method for Sulfur in
Petroleum and Petroleum Products by Energy Dispersive X-ray
Fluorescence Spectrometry Standard Test Method for Distillation of
Petroleum Products and Liquid Fuels at Atmospheric Pressure
(Includes all amendments and changes 2/9/2024). Standard Test Methods for Flash Point by
Pensky-Martens Closed Cup Tester Standard Test Method for Pour Point of
Petroleum Products (Includes all amendments and changes
11/29/2022). Standard Test Method for Kinematic
Viscosity of Transparent and Opaque Liquids (and Calculation of
Dynamic Viscosity) Standard Test Method for Ash from
Petroleum Products Standard Test Method for Ramsbottom
Carbon Residue of Petroleum Products |
Doporučujeme:
Aktualizace technických norem
Chcete mít jistotu, že používáte pouze platné technické normy?
Nabízíme Vám řešení, které Vám zajistí měsíční přehled o aktuálnosti norem, které používáte.
Chcete vědět více informací? Podívejte se na tuto stránku.
