Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Method for Carboxyl End Group Content of Polyethylene Terephthalate (PET) YarnsPřeložit název
NORMA vydána dne 1.12.2020
Označení normy: ASTM D7409-15(2020)
Datum vydání normy: 1.12.2020
Kód zboží: NS-1013171
Počet stran: 3
Přibližná hmotnost: 9 g (0.02 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
carboxyl end group content, CEG, geogrid yarns, geotextile yarns, PET, polyethylene terephthalate,, ICS Number Code 59.080.20 (Yarns)
|Significance and Use|
5.1This test method can be used for manufacturing quality control or manufacturing quality assurance purposes to determine the CEG concentration of PET yarns used in either geogrids or geotextiles.
5.2The CEG content of the PET yarns may have an influence on the properties of the geosynthetic, such as its hydrolysis resistance. The lower the value, the higher the hydrolysis resistance of the yarns.
5.3This test does not set the limiting (maximum) value for various engineering applications. Such a specification is a decision of the design engineer, owner, and/or regulator.
1.1This test procedure is based significantly on the GRI GG7 test procedure, Carboxyl End Group Content of Polyethylene Terephthalate (PET) Yarns.
1.2 This test method is used to determine the concentration, in mmol/kg, of carboxyl end groups (CEG) found in poly(ethylene terephthalate) (PET) yarns by titration.
1.3This test is applicable to geogrid yarns that are made from PET resin.
Note 1:This test is also applicable to high-strength geotextile yarns that are made from PET and are used in reinforcement applications.
1.4The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.5This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.6This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
|2. Referenced Documents|
Poslední aktualizace: 27.01.2023 (Počet položek: 2 662 456)
© Copyright 2023 NORMSERVIS s.r.o.