Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Method for Multiple Stress Creep and Recovery (MSCR) of Asphalt Binder Using a Dynamic Shear RheometerPřeložit název
NORMA vydána dne 1.3.2020
Označení normy: ASTM D7405-20
Datum vydání normy: 1.3.2020
Kód zboží: NS-988568
Počet stran: 4
Přibližná hmotnost: 12 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
asphalt binder, creep and recovery, DSR, dynamic shear rheometer, elastic recovery, MSCR, non-recoverable creep compliance, polymer-modified asphalt,, ICS Number Code 91.100.50 (Binders. Sealing materials)
|Significance and Use|
5.1 This test method is used to identify the presence of elastic response in a binder and the change in elastic response at two different stress levels. Non-recoverable creep compliance has been shown to be an indicator of the resistance of an asphalt binder to permanent deformation under repeated load.
5.2 This test method is also useful as a surrogate for other test methods used to measure elasticity in asphalt binders such as Test Method (toughness and tenacity), Test Method (elastic recovery), and Test Method (DSR phase angle).
Note 2: The quality of the results produced by this standard are dependent on the competence of the personnel performing the procedure and the capability, calibration, and maintenance of the equipment used. Agencies that meet the criteria of Specification are generally considered capable of competent and objective testing, sampling, inspection, etc. Users of this standard are cautioned that compliance with Specification alone does not completely ensure reliable results. Reliable results depend on many factors; following the suggestions of Specification or some similar acceptable guideline provides a means of evaluating and controlling some of those factors.
1.1 This test method covers the determination of percent recovery and non-recoverable creep compliance of asphalt binders by means of multiple stress creep and recovery (MSCR) testing. The MSCR test is conducted using the dynamic shear rheometer (DSR) at a specified temperature.
1.2 This standard is appropriate for unaged material, material aged in accordance with Test Method (RTFOT), material aged in accordance with Practice (PAV), and material aged in accordance with both Test Method and Practice .
Note 1: The majority of development work on this test method was performed on material aged in accordance with Test Method (RTFOT).
1.3 The percent recovery is intended to provide a means to determine the presence of elastic response and stress dependence of polymer-modified and unmodified asphalt binders.
1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.5 The text of this standard references notes and footnotes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the standard.
1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
|2. Referenced Documents|
Poslední aktualizace: 17.08.2022 (Počet položek: 2 584 253)
© Copyright 2022 NORMSERVIS s.r.o.