Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Method for Cone/Plate Viscosity at a 500 s-1 Shear Rate
Automaticky přeložený název:
Standardní zkušební metoda pro Cone / Plate Viskozita při 500 s-1 smykové rychlosti
NORMA vydána dne 1.2.2012
Označení normy: ASTM D7395-07(2012)
Poznámka: NEPLATNÁ
Datum vydání normy: 1.2.2012
Kód zboží: NS-38353
Počet stran: 3
Přibližná hmotnost: 9 g (0.02 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
No. 4 Ford cup-alternative to, rheology-paints/related coatings/materials, viscometer-cone/plate, viscosity-paints/related coatings/materials, Viscosity--paints/related coatings/materials, ICS Number Code 87.040 (Paints and varnishes)
Significance and Use | ||||
This test has been used to measure viscosities of automotive topcoats in place of No. 4 Ford cup measurements and has provided an equivalent ability to evaluate whether the paint meets specifications and is sprayable. The method could be considered as an alternative to No. 4 Ford cup and other efflux cup measurements for other products as well. The type of viscometer described in this method gives better temperature control than Ford and other efflux cups and is expected to give better precision. This test method is suitable for all paints and related materials whether they are Newtonian in behavior or not. |
||||
1. Scope | ||||
1.1 This test method covers the determination of the viscosity of paints and related products using a cone/plate viscometer at a shear rate of 500 s-1. 1.2 Viscosity values obtained by this method may be used as an alternative to results from No. 4 Ford cup measurements. The values from this method do not replicate Ford cup results, but can be used for quality control, producer-user specifications and viscosity reduction in the same manner that Ford cups are used. 1.3 If viscosity at a higher shear rate is needed, Test Method D4287, which describes viscosity measurement at 10 000 to 12 000 s-1 may be used. 1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||
2. Referenced Documents | ||||
|
Poslední aktualizace: 22.11.2024 (Počet položek: 2 206 568)
© Copyright 2024 NORMSERVIS s.r.o.