Cookies
Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
ASTM D7193-17
Standard Specification for Unsintered Pigmented Polytetrafluoroethylene (PTFE) Extruded Film or Tape
Přeložit název
NORMA vydána dne 1.9.2017
Informace o normě:
Označení normy: ASTM D7193-17
Poznámka: NEPLATNÁ
Datum vydání normy: 1.9.2017
Kód zboží: NS-795767
Počet stran: 4
Přibližná hmotnost: 12 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Kategorie - podobné normy:
Anotace textu normy ASTM D7193-17 :
Keywords:
apparent density, elongation, extruded, film, fluorocarbon film, pigmented, PTFE, PTFE tape, tape, tensile, thread seal tape, unsintered,, ICS Number Code 83.140.10 (Films and sheets)
Doplňující informace
| 1. Scope | ||||||||||||||||||||||||||||||
|
1.1 This specification covers unsintered, pigmented, extruded films or tapes manufactured from polytetrafluoroethylene, in nominal thicknesses from 0.025 mm (0.001 in.) to 0.51 mm (0.020 in.), which are ≥99 % virgin PTFE in composition prior to introducing pigments. Note 1: For unsintered non-pigmented products refer to
Specification D6585.
1.1.1 The use of recycled PTFE for production of unsintered extruded films or tapes has not been identified at this time. When commercial usable processes and materials are available, this specification will be revised to include recycled materials. 1.2 The values stated in SI units are detailed in IEEE/ASTM SI-10 are to be regarded as the standard. The values given in parentheses are for information only. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health and environmental practices and determine the applicability of regulatory limitations prior to use. Note 2: Although this specification and ISO 13000-1 (1997) and
ISO 13000-2 (1997) differ in approach or detail, data obtained
relating to specific properties, using either are technically
equivalent.
Note 3: This specification is intended to be a complement to
Specification D6585, as the
materials covered herein vary significantly enough due to their
additives to warrant a stand-alone set of requirements.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||||||||||||||||||||
| 2. Referenced Documents | ||||||||||||||||||||||||||||||
|
Doporučujeme:
