Cookies
Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
ASTM D7064/D7064M-21
Standard Practice for Open-Graded Friction Course (OGFC) Asphalt Mixture Design
Přeložit název
NORMA vydána dne 1.5.2021
Informace o normě:
Označení normy: ASTM D7064/D7064M-21
Datum vydání normy: 1.5.2021
Kód zboží: NS-1024151
Počet stran: 7
Přibližná hmotnost: 21 g (0.05 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Kategorie - podobné normy:
Anotace textu normy ASTM D7064/D7064M-21 :
Keywords:
bituminous paving mixtures, mix design, open-graded friction course, surface treatments,, ICS Number Code 93.080.20 (Road construction materials)
Doplňující informace
| Significance and Use | ||||||||||||||||||||||||||||||||||||||||||||||||||
|
5.1?The procedure described in this practice is used to design OGFC asphalt mixtures that will provide good performance in terms of permeability (tending to reduce hydroplaning and potential for skidding) and durability when subjected to high volumes of traffic. |
||||||||||||||||||||||||||||||||||||||||||||||||||
| 1. Scope | ||||||||||||||||||||||||||||||||||||||||||||||||||
|
1.1?This practice covers the mix design of open-graded friction course (OGFC) using the Superpave Gyratory Compactor (SGC) or other suitable forms of compaction. The OGFC asphalt mixture design is based on the volumetric properties of the asphalt mixture in terms of air voids and the presence of stone-on-stone contact. Information found in Guide D6932/D6932M should be reviewed before starting the mix design. Where applicable, Specification D3666 should be applied as a minimum for agencies testing and inspecting road and paving materials. 1.2?The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard. 1.3?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||||||||||||||||||||||||||||||||||||||||
| 2. Referenced Documents | ||||||||||||||||||||||||||||||||||||||||||||||||||
|
Doporučujeme:
Aktualizace zákonů
Chcete mít jistotu o platnosti užívaných předpisů?
Nabízíme Vám řešení, abyste mohli používat stále platné (aktuální) legislativní předpisy.
Chcete vědět více informací? Podívejte se na tuto stránku.
