Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Method for Determination of Total Sulfur in Liquid Hydrocarbons and Hydrocarbon-Oxygenate Blends by Gas Chromatography with Flame Photometric Detection
Automaticky přeložený název:
Standardní testovací metodu pro stanovení celkového obsahu síry v tekutých uhlovodíků a uhlovodíků-okysličovadlo Směsi plynovou chromatografií s Flame fotometrickou detekcí
NORMA vydána dne 1.4.2016
Označení normy: ASTM D7041-16
Poznámka: NEPLATNÁ
Datum vydání normy: 1.4.2016
Kód zboží: NS-636020
Počet stran: 5
Přibližná hmotnost: 15 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
flame photometric detector, gas chromatography, total sulfur,, ICS Number Code 75.160.20 (Liquid fuels)
Significance and Use | ||||||||||
4.1 This test method can be used to determine total sulfur levels in process feeds and finished products that fall within the scope of this test method. 4.2 Low levels of sulfur in process feed stocks can poison expensive catalysts used in petroleum refining processes. This test method can be used to monitor sulfur levels in these feedstocks. |
||||||||||
1. Scope | ||||||||||
1.1 This test method covers the determination of total sulfur in liquid hydrocarbons with a final boiling point less than 450 °C by gas chromatography using a flame photometric detector. 1.2 This test method is applicable for total sulfur levels from 0.5 mg S/kg to 100 mg S/kg. Note 1: The pooled limit of quantification (PLOQ) derived from
the 2002 interlaboratory cooperative test program was determined to
be 1 mgS/kg.
Note 2: Samples can also be tested at other total sulfur
levels, but the precision statements may not apply.
1.3 The values stated in SI units are to be regarded as standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements see Section 7. |
||||||||||
2. Referenced Documents | ||||||||||
|
Poslední aktualizace: 28.04.2024 (Počet položek: 2 896 137)
© Copyright 2024 NORMSERVIS s.r.o.