Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Practices for Preparation of Solvent and Water Based Ink Resin Solutions
Přeložit název
NORMA vydána dne 1.6.2020
Označení normy: ASTM D6989-03(2020)
Datum vydání normy: 1.6.2020
Kód zboží: NS-997842
Počet stran: 3
Přibližná hmotnost: 9 g (0.02 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
blenders, cold cuts, ink resins, laboratory roller mills, resin solutions,, ICS Number Code 87.080 (Inks. Printing inks)
Significance and Use |
4.1 This practice provides a means of preparing resin solutions by the “cold cut” method, modeling high-shear production dispersion techniques. |
1. Scope |
1.1 These practices describe laboratory procedures for preparing a solvent or water based ink resin solution in low boiling solvent or alkaline water using two types of lab equipment; (1) an industrial blender (Sections 3 – 7), and (2) a laboratory roller mill (Sections 8 – 12). Note 1: ASTM Subcommittee D01.37 recommends using the
industrial blender where possible.
1.2 These practices use laboratory equipment generally available in a normal, well-equipped laboratory. 1.3 These procedures are for use with ink resins intended mainly for liquid (for example, flexographic and rotogravure) inks. The type of resins is typically, but not limited to, acrylic and styrene/acrylic copolymers, polyamides, polyesters, polyvinylbutyral, and maleated/fumarated rosin esters. 1.4 The typical low boiling solvents to be used include ethanol, isopropanol, n-propanol, ethyl acetate, isopropyl acetate, and 1.5 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
Poslední aktualizace: 12.05.2025 (Počet položek: 2 199 201)
© Copyright 2025 NORMSERVIS s.r.o.